Automotive Manual, Car Parts and News

Step 1: Position truck on a flat surface and lift front wheels off of ground using jack stands or a (2) two post lift if available, and remove the driver’s side front wheel. Next loosen and remove the Upper ball joint nut, Tie rod nut and Sway bar nut on the same side of the […]

[Read more →]

Step 1: Prior to lifting the vehicle it is recommended that you measure the stock height of the vehicle so that you have a base line to gauge the height of the vehicle. Measure the vehicle from the bottom of the wheel to the lip of the fender. Position truck on a flat surface and […]

[Read more →]

Get ready to install coil spring leveling kit.
1. Lift front wheel assemblies.
a. If so equipped, remove two caps (4) from front wheels (5)
b. Loosen eight lug nuts (6) each from two front wheels (5).
c. Using a hydraulic jack, slowly lift front of vehicle so that two front tires (7) are three to five inches off […]

[Read more →]

Installation Instructions Front:
1. Layout all parts and check against bill of materials and read instructions before beginning installation
2. Jack the front of the truck accordance to manufacturer recommendations and support with jack stands, so that the front tire are off the ground.
3. Remove front tires.
4. Remove the sway bar link from sway bar.
5. Remove the […]

[Read more →]

We recommend installation be done by a trained professional.
• Read instructions carefully before attempting installation.
• Secure and properly block vehicle prior to installation.
Note: Carli Suspensions’ Heavy Duty Upper Ball Joints need to be disassembled prior to installation. The following steps will be the installation of the ball joint cup only.

[Read more →]

Step 1: Prior to lifting the vehicle it is recommended that you measure the stock height so that you have a base line measurement. Measure from the bottom of the wheel to the lip of the fender, as in Insert A. Position truck on a flat surface and lift vehicle by the frame so that […]

[Read more →]

1. To begin installation, block rear wheels and apply parking brake so that the vehicle is stable and cannot roll forward or back. Lift front of the vehicle on appropriate lift points, such as the frame, and support the frame with jack stands on both passenger and driver sides. Remove front wheels.
2. Position a floor […]

[Read more →]

1. Layout all parts and check quantities against the Bill of Materials. Completely read instructions before beginning installation.
2. Jack the front of the vehicle in accordance to manufacturer recommendation and support with jack stands, so that the front two tires are off the ground
3. Remove the front tires/wheels.
4. Disconnect the steering linkage and push forward, […]

[Read more →]

Step 1: Position truck on a flat surface and lift the front wheels off the ground using jack stands or a (2) two post lift if available. Remove the wheels and tires on both sides. Remove the two lower sway bar nuts on both sides of truck. (Insert A) Remove the driver’s side cotter pin […]

[Read more →]

Front Installation
2. Raise vehicle until front tires are clear, support the vehicle.
3. Remove the front tire and wheel assembly.
4. Remove the lower stabilizer link bolt and move sway-bar assembly out of way.
5. Remove the upper ball joint nut.
6. Separate the upper ball joint from the spindle.
7. Remove the strut assembly and install the strut spacer […]

[Read more →]