Automotive Manual, Car Parts and News

Jack-it, Inc. strongly recommends this kit be installed by a professional mechanic. Installing this kit will not strengthen or reinforce the stock frame of the vehicle, nor will it increase rollover protection. This kit is designed to level the front end of the vehicle in relation to the height of the rear end. We strongly […]

[Read more →]

Installation requires a professional mechanic. Prior to beginning, inspect the vehicles steering, driveline, and brake systems, paying close attention to the suspension link arms and bushings, stabilizer bars and bushings, tie rod ends, pitman arm, ball joints and wheel bearings. The overall vehicle must be in excellent working condition; repair or replace all worn parts. […]

[Read more →]

Each lift kit, and options to lift kits, are packaged separately. Therefore installation procedures are covered in separate instructions. Familiarize yourself with each specific set of instructions before beginning.
INTRODUCTION
• Installation by a professional mechanic is recommended. Use of the appropriate tools, a Dodge service manual, and a shop hoist can greatly reduce installation time.

[Read more →]

Prior to installation, carefully inspect the vehicle’s steering and drive train components. Be sure to check ball joints, tie rod ends, pan-rod bar, and control arm bushings. Everything must be tight and in good working condition.
• We recommend installation be done by a trained professional
• Read instructions carefully before attempting installation
• Secure and properly block […]

[Read more →]

Installation requires a professional mechanic. Prior to beginning, inspect the vehicles steering, driveline, and brake systems, paying close attention to the suspension link arms and bushings, anti-sway bars and bushings, tie rod ends, pitman arm, ball joints and wheel bearings. Also check the steering sector-to-frame and all suspension-to-frame attaching points for stress cracks. The overall […]

[Read more →]

Park your truck on flat level surface. Chock the rear wheels. Loosen front lug nuts. Raise the front with a floor jack. Support the frame with jack stands. Remove front wheels.
NOTE : ALWAYS USE JACK STANDS - NEVER RELY ON JACKS ONLY!!
1) Starting on the drivers side, locate the height adjusting bolt at the rear […]

[Read more →]