Automotive Manual, Car Parts and News

RSS Feed

Free PDF Download, Car Parts and Automotive News

BMW-AUX Pie Part Installation Instructions

June 6th, 2011 · No Comments

The BMW-AUX will convert the CD changer port of any 1995-2003 BMW radio with to an auxiliary input.
DO NOT force connectors together as pin damage may occur. This installation will be flawless if you take your time making the connections described below. Following the installation sequence below is critical to ensure proper recognition of the [...]

[Read more →]


Chevrolet C-5 Corvette Header System Installation Instructions

January 2nd, 2011 · No Comments

Stock System Removal
Under the Hood: Place the vehicle up on jack stands or a hydraulic lift to provide access to the bottom of the vehicle. For safety and to protect you car’s electrical system, remove the ground cable from the negative battery terminal.
Carefully remove the fuel rail covers, from both the top left and right [...]

[Read more →]


How to change a starter in a 1998 Cadillac Deville?

December 25th, 2010 · No Comments

I know where the starter is located but i have never taken the air intake manifold off to reach a starter need help.
- Get a digital camera. take off the air cleaner and snap a few pictures and download to your computer. take some more off, take pictures and download. after you get the intake [...]

[Read more →]


2002-UP Subaru Impreza In-Dash Installation Kit

November 17th, 2010 · No Comments

This premium installation kit is for select 2002-Up Subaru vehicles. Included are all the parts you need to mount your car stereo/cassette or CD player into your vehicle’s dash. Refer to the individual instruction in this manual to remove your vehicle’s factory radio and assemble the kit.
CAUTION: Disconnect your vehicle’s negative battery terminal before the [...]

[Read more →]


2003-06 Infiniti G35 Sedan Dyno-Proven Cold Air Intake System

October 22nd, 2010 · No Comments

Before installing any parts of this system, please read the instructions thoroughly. If you have any questions regarding installation please contact the dealer you purchased this product from. Installation DOES require some mechanical skills. A qualified mechanic is always recommended. *Do not attempt to install the intake system while the engine is hot.
The installation may [...]

[Read more →]


1992 Mitsubishi Mirage Electrical Starter

September 28th, 2010 · No Comments

Starter is a conventional 12-volt, 4-pole brush-type motor, with direct or gear reduction drive. The starter-mounted solenoid shifts overrunning clutch and pinion into flywheel when starter is energized.
TROUBLE SHOOTING
NOTE: See the TROUBLE SHOOTING – BASIC PROCEDURES article in the GENERAL TROUBLE SHOOTING section.
NO LOAD TEST
CAUTION: Perform tests in less than 10 seconds to prevent coil [...]

[Read more →]


Toyota Kit Components 99-8100 Installation Instructions

August 29th, 2010 · No Comments

2-SHAFT HEAD UNITS: Snap the Faceplate onto the front of the Radio Housing. (For applications using Faceplate #2, cut and remove the bottom portion of the Faceplate). Slide the aftermarket head unit into the kit and secure with shaft nuts. (see Fig. A)
DIN HEAD UNITS: Cut and remove the shaft supports from the Faceplate and [...]

[Read more →]


Toyota Celica 1.8L Part Number 57-0502 Installation Instructions

August 29th, 2010 · No Comments

Toyota Corolla 1.6L 16v 116bhp (4A-FE Engine) 1992 – 1997
Disconnect the negative battery terminal from the battery. Carefully disconnect & remove the air temperature sensor from the air box lid. (Fig. 1) Unclip and remove the intake hose from the throttle housing. Unclip and remove the air box lid assembly from the vehicle. Unscrew and [...]

[Read more →]


96 BMW 3 Series/M3 (E36) Front Midrange / Tweeter Installation Instructions

July 26th, 2010 · No Comments

Tools Required for BMW Front Midrange / Tweeter Installation: (All the below are readily available at your local auto parts store) • Panel Removal Tool • Torx T20 screwdriver • 8mm socket wrench • Small, Straight Pick Tool • Hot Glue Gun w/Glue Sticks We’ve broken down our instructions into each task so that you [...]

[Read more →]


AuxMod Basic Installation Instructions

April 26th, 2010 · No Comments

We have designed AuxMod to be reasonably easy to use and install, as well as safe. This guide will outline the correct installation procedures to follow when installing the unit in a Mazda Radio. This guide assumes that you have the capability to remove and install the radio from your vehicle and that you can [...]

[Read more →]




?>