Automotive Manual, Car Parts and News

The mounting procedure outlined below covers 1992 – 1996 FORD F150 trucks. You will need to refer to the illustrations and familiarize yourself with each of the undercarriage components and their relative position to each other. Then proceed as follows:
1. Remove the front bumper. If the truck is equipped with a front stabilizer bar, remove […]

[Read more →]

Installation Instructions Front:
1. Layout all parts and check against bill of materials and read instructions before beginning installation
2. Jack the front of the truck accordance to manufacturer recommendations and support with jack stands, so that the front tire are off the ground.
3. Remove front tires.
4. Remove the sway bar link from sway bar.
5. Remove the […]

[Read more →]

FRONT OF FRONTIER
1. Park vehicle on level concrete surface.
2. Center and lock the steering wheel.
3. Block the rear wheels of the vehicle to prevent vehicle from moving in either direction.
4. Jack up the vehicle from the lift point in Figure A.
5. Support the vehicle with jack stands from the points in Figure A.
6. Remove the […]

[Read more →]

Step 1: Position truck on a flat surface and lift the front wheels off the ground using jack stands or a (2) two post lift if available. Remove the wheels and tires on both sides. Remove the two lower sway bar nuts on both sides of truck. (Insert A) Remove the driver’s side cotter pin […]

[Read more →]

FRONT OF XTERRA
1. Park vehicle on level concrete surface.
2. Center and lock the steering wheel.
3. Block the rear wheels of the vehicle to prevent vehicle from moving in either direction.
4. Jack up the vehicle from the lift point in Figure A.
5. Support the vehicle with jack stands from the points in Figure A.
6. Remove the […]

[Read more →]

Step 1:
Position truck on a flat surface and lift the front wheels off the ground using jack stands or a (2) two post lift if available. Remove the wheels and tires on both sides. Remove the two lower sway bar nuts on both sides of truck. (Insert A)
Remove the driver’s side cotter pin and loosen […]

[Read more →]

Park your truck on flat level surface. Chock the rear wheels. Loosen front lug nuts. Raise the front with a floor jack. Support the frame with jack stands. Remove front wheels.
NOTE : ALWAYS USE JACK STANDS - NEVER RELY ON JACKS ONLY!!
1) Starting on the drivers side, locate the height adjusting bolt at the rear […]

[Read more →]

Installation of this baseplate requires removing the headlights, the small in the middle of the upper bumper and the bumper molding itself. Holes will need to be drilled in the vehicle’s frame.
1. Read the General Instruction Sheet included with this base plate.
2. Remove the head lights so that the bumper molding can be removed. The […]

[Read more →]

THE EDGE highly recommends use of part number EDG3-9290 (Adjustable Pan-rod Bar) if part number EDG3-3000 is used as the primary and only leveling kit for the vehicle. If this kit is being added to an existing kit that has been previously installed on the vehicle, continue with the following instructions without this recommendation.

[Read more →]