Automotive Manual, Car Parts and News

MOUNTING LOCATION: The enclosure mounts behind the seat of a regular cab truck.
INSTALLATION: Follow the steps below
1. Move seat and seat back all the way forward. You do not need to remove the seat.
2. If truck is equipped with a rear tool tray, this tray must be removed to mount enclosure. Remove rubber caps to […]

[Read more →]

The JackRabbit is designed to carry rainwater from the cover into the canister and then out through the drains. Most truck models have standard OE drain holes or plastic/rubber access ports in the front of the truck bed. Check to make sure your truck has the OE drain holes so that drilling into the sheet […]

[Read more →]

The recommended push beam height for this undercarriage assembly is 12-1/2″ from the center of the push beam to level ground. DO NOT exceed 14-1/2″ in height for this undercarriage.
WARNING: Always perform vehicle undercarriage installations with the keys removed from the vehicle’s ignition. Properly tag the ignition switch to alert others work is being performed […]

[Read more →]

The JackRabbit is designed to carry rainwater from the cover into the canister and then out through the drains. Most truck models have standard OE drain holes or plastic/rubber access ports in the front of the truck bed. Check to make sure your truck has the OE drain holes so that drilling into the sheet […]

[Read more →]

The FP-102 (‘01-Newer Excursion and ’99-Newer F250 - F750) is a no-holes base. Installing a no-holes base does not require drilling any holes into the vehicle. The base mounts under the seat bracket and is compressed to the floor using the seat bolts. Note: For extra stability, the use of a Brace 2 or Brace […]

[Read more →]

This document provides all the necessary information to allow your Whelen product to be properly and safely installed. Before beginning the installation and/or operation of your new product, the installation technician and operator must read this manual completely. Important information is contained herein that could prevent serious injury or damage.
INSTALLATION:
1. Position the lightbar in the […]

[Read more →]

Prep
WARNING: Do not perform this install near a flame source due to the risk of fire or explosion from gas fumes. Use a jack to lift rear of vehicle. Remove the passenger side rear tire. Remove the wheel well cover to expose the fuel filler neck behind the quarterpanel.
Note: For manual locking or manual non-locking […]

[Read more →]

Step 1: Position truck on a flat surface and lift front wheels off of ground using jack stands or a (2) two post lift if available, and remove the driver’s side front wheel. Next loosen and remove the Upper ball joint nut, Tie rod nut and Sway bar nut on the same side of the […]

[Read more →]

Installation Instructions: Solid Bench Seat
Step One: Tilt the back of the rear seat forward. Remove jack handles from current plastic tray (if applicable). Using an 8mm socket remove bolts holding current plastic tray. Remove tray from truck. If you experience problems removing bolts you may need to apply upward pressure from under tray.
Step Two: Set […]

[Read more →]

1. Take Parts A-F and assemble them together as shown on Diagram A with the straight pin installed. IMPORTANT NOTE: Part D is a critical safety component. Notice the tabs on the part. Which ever side you are placing the Tool Box Step on your vehicle, the tabs on Part D must be facing down […]

[Read more →]