Automotive Manual, Car Parts and News

Toyota Corolla 1.6L 16v 116bhp (4A-FE Engine) 1992 – 1997
Disconnect the negative battery terminal from the battery. Carefully disconnect & remove the air temperature sensor from the air box lid. (Fig. 1) Unclip and remove the intake hose from the throttle housing. Unclip and remove the air box lid assembly from the vehicle. Unscrew and […]

[Read more →]

1. Disconnect the negative battery cable, and remove the factory “accordion” style intake hose by loosening the two factory clamps.
2. Loosen the two 10mm bolts securing the factory air box to the intake manifold.
3. Disconnect the air temperature sensor wire on the front of the factory air box & twist to remove the sensor from […]

[Read more →]

Removing the stock air inlet system:
a) Loosen the five screws securing the stock air box lid. Remove the air box lid from the vehicle.
b) Remove the Inlet Air Temperature (IAT) sensor. The metal band will need to be pried off with a flat-head screwdriver. Use care to avoid damaging the IAT sensor.
c) Remove the air […]

[Read more →]

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the air temp. sensor electrical connection.
3. Loosen the hose clamps at the turbo inlet and the airbox outlet as shown.
4. Remove the intake tube from the vehicle as shown.
5. Loosen and remove the 10mm nut that retains the airbox to the […]

[Read more →]

Remove air cleaner assembly.
a) Disconnect air tube from air box.
b) Remove air box lid and filter.
c) Remove air cleaner assembly from fender. Loosen nut at rear near washer reservoir. Remove plastic stud from filter box snout, then remove assembly from vehicle.

[Read more →]

Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS […]

[Read more →]

1. Disconnect the negative battery cable, then, loosen the hose clamp on the factory intake tube. Disconnect the electrical connector from the Mass Air Sensor and unclip the wiring from the air box lid.
2. Unclip the factory air box lid from the base and remove from engine compartment. Remove original flat panel filter.
3. Using a […]

[Read more →]

1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the mass air sensor electrical connection.
3. Loosen the hose clamps on the intake hose at the throttle body and mass air sensor.
4. Using a 10mm socket, loosen and remove the bolt that holds the vacuum switch to the airbox lid.
5. Release the […]

[Read more →]

NOTE: FAILURE TO FOLLOW INSTALLATION INSTRUCTIONS AND NOT USING THE PROVIDED HARDWARE MAY DAMAGE THE INTAKE TUBE, THROTTLE BODY AND ENGINE.
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Unlatch the four air box lid retaining clips.
3. Lift the air box lid up; then, disconnect the stock intake tube from the air […]

[Read more →]