Automotive Manual, Car Parts and News

The recommended push beam height for this undercarriage assembly is 12-1/2″ from the center of the push beam to level ground. DO NOT exceed 14-1/2″ in height for this undercarriage.
WARNING: Always perform vehicle undercarriage installations with the keys removed from the vehicle’s ignition. Properly tag the ignition switch to alert others work is being performed […]

[Read more →]

Prep
WARNING: Do not perform this install near a flame source due to the risk of fire or explosion from gas fumes. Use a jack to lift rear of vehicle. Remove the passenger side rear tire. Remove the wheel well cover to expose the fuel filler neck behind the quarterpanel.
Note: For manual locking or manual non-locking […]

[Read more →]

Before Starting Installation
1. Carefully read all warnings and instructions completely before beginning.
2. Verify all parts have been received in this kit by checking the parts list at the end of this document.
3. Only install this kit on the vehicle for which it is specified. If anytime during the installation you encounter something different from what […]

[Read more →]

1. Before beginning the installation, please read the instructions thoroughly and verify that the hardware kit is complete. If any of the pieces listed above are missing, call you distributor immediately to obtain the necessary items.
2. Identify your product´s components. Tips: The front of the side bar has the step pad farther from the edge […]

[Read more →]

All hardware should be tightened only enough to ensure safety during assembly. Fully tighten all hardware after entire assembly is completed.
1. Remove the plastic air dam from the bottom of the front bumper. The air dam cannot be reinstalled when this mount kit is on the truck and should be returned to the vehicle owner […]

[Read more →]

For easier assembly and installation, vehicle and all snowplow components should be on a smooth, level, hard surface, such as concrete.
1. Remove license plate bracket and retain for vehicle owner. Remove bumper from bumper brackets. Retain fasteners.
2. Remove bumper brackets from frame. Retain fasteners.
Diesel applications: On these applications, you must first remove the top two […]

[Read more →]

1. Remove stock dash panel by snapping it off the dash. See the shop manual for more information.
2. Remove small storage pocket from lowest position on panel. (Some vehicles may have seat warmer, shift on the fly, etc. switches installed in this position. The switches will have to be relocated to install the dash pod.) […]

[Read more →]

For easier assembly and installation, vehicle and all snowplow components should be on a smooth, level, hard surface, such as concrete.
1. Remove bumper from bumper brackets. Retain fasteners.
2. Remove bumper brackets from frame. Diesel and V10 applications: On these applications you must first remove the top two intercooler fasteners. Then push intercooler up and out […]

[Read more →]

1) Front brackets are identical and are simply turned 180 degrees out so face of bracket is facing outside of truck.
2) Bars can be mounted either side and are identical.
3) Body mount torque is 65 ft.-lbs.
4) Holes in rocker panel are usually covered with black or grey tape from manufacturer

[Read more →]

Get ready to install the kit.
1. Remove the shift transfer case shift linkage.
a. If present on your vehicle, remove four bolts and skid plate from the frame under the transmission and transfer case.
b. Remove two rubber bushings and transfer case shift linkage from shift lever and transfer case.
2. Remove the front bumper.
a. Remove nine panel […]

[Read more →]