Automotive Manual, Car Parts and News

Pillar installation Directions: Read directions before starting installation Model# (17212 Dual), (17213 Triple) Fits 03+ Dodge Ram
1)  Remove Stock Pillar by removing the two  screws located under the caps of pillar handle.
2)  Install Gauges in new pillar.
3)  Tape or secure gauge wiring to back of pillar.
4)  Install new pillar in place of old pillar.
5)  Use provided screw to hold pillar in place:
•  Make sure screw is aligned with factory hole to avoid cross threading
•  Don’t over tighten screw.

[Read more →]

Get ready to install coil spring leveling kit.
1. Lift front wheel assemblies.
a. If so equipped, remove two caps (4) from front wheels (5)
b. Loosen eight lug nuts (6) each from two front wheels (5).
c. Using a hydraulic jack, slowly lift front of vehicle so that two front tires (7) are three to five inches off […]

[Read more →]

Proper installation of this kit requires knowledge of the factory recommended procedures for removal and installation of original equipment components. We recommend that the factory shop manual and any special tools needed to service your vehicle be on hand during the installation. Installation of this kit without proper knowledge of the factory recommended procedures may […]

[Read more →]

Step 1
Raise Vehicle, and R vehicle, and R vehicle, and Remove Wheels
A level, stable and clean surface, suitable for supporting the vehicle on jack-stands, should be used for the installation.
Warning: Never leave any vehicle support vehicle supported with only a jack. Always use jack-stands.
Break loose the lug nuts on both rear wheels before jacking up […]

[Read more →]

PROCEDURE:
• Install camshafts, matching each cam to present cams in engine.
NOTE: Most cams are marked in positioning slot at rear of cam s haït
Example: LE=Lefl ExhausL Follow Ford procedure for Lorque
Pattern and values on cam caps-diagram 10,11
* Ensure key ways are down - use positioning tool - diagram 8.S

[Read more →]

Installation (numbers in brackets refer to diagram)
1. Ensure crankshaft at TDC on No.1 cylinder. Use dial gauge [6]
2. Hold camshaft sprockets. Use tool Nos. 1.822.155.000 and 1.822.146.000 [13] & [14]. Slacken bolt(s) of each camshaft sprocket.
3. Remove third bearing cap from each camshaft [15] & [16]. NOTE: Mark bearing caps before removal from identification.
4. Fit […]

[Read more →]