Getting started
- Chock the other 3 wheels on both sides
- Release handbrake
- Put the gearbox into neutral
- Loosen wheel nuts
- Jack up the car
- Remove wheel nuts + wheel
- Place jack-stand under car for safety
Mazda RX7 1st Gen Rear Brake-Caliper Rebuild
November 4th, 2009 · No Comments
Mercury Switch Removal Procedures From Vehicle Hood and Trunk Lights
October 9th, 2009 · No Comments
Removal and Replacement of Mercury Switch in 1985-1995 Chrysler Hood Lighting Assembly
1. Remove the wiring clip from the back of assembly by sliding a screwdriver under the clip and sliding the clip back to remove the power source
2. Remove the mercury switch holder from the back of the lighting assembly by sliding a screwdriver under […]
Impedance Match Adapter (IMP-1000)
September 8th, 2009 · No Comments
The Impedance Match Adapter Box is used in conjunction with all Trans-Doctor cable sets, whether you’re using the Universal or the transmission specific cables. This impedance match box contains the appropriate circuitry to make sure the TransDoctor can actuate all modern transmission solenoids, regardless of year, make and model. The internal impedance (reactance and resistance) […]
ACURA Manual 815/825/835/855
September 8th, 2009 · No Comments
The Acura® manual is an air displacement micropipette line intended for the accurate, precise and easy pipetting. The single channel models cover volumes ranging from 0.1 µL to 10 mL. Available in eight models with 8 or 12 channels, the multichannels are perfectly adapted for a continuous microplate pipetting in the 0.5 to 350 µL […]