Automotive Manual, Car Parts and News

Installation
1. Place the coach on a level concrete surface. Measure each side of the coach from the front wheel well to the ground. Record these measurements as you will need them in Step 9.
2. Place a jack under each side of the frame just behind the leaf spring shackles. Jack the coach up high enough […]

[Read more →]

Your third brake light kit was built to high quality standards to provide you with years of reliable service. This manual should serve as a guide for installing a third brake light kit on your vehicle. Although this guide is thorough, each installation is different, so it can not cover all applications.
You can install the […]

[Read more →]

Read all instructions before starting any work.
1. Remove the O.E. inlet pipe/muffler/tail pipe welded assembly from the vehicle. Lubricate the rubber isolators with WD-40, or a similar product, to aid in removal of the metal rod hangers. Do NOT remove the exhaust pipe just ahead of the welded muffler assembly
2. Install DynoMax inlet pipe […]

[Read more →]

If you are not familiar with the use of hand tools or not accustomed to working on motor vehicles, have a dealer or accessory shop install the X2000 Platinum Series EZ-Lift Lid. Carefully read all the instructions prior to attempting to fit the Lid. Before fitting the Lid, park the vehicle on level ground in […]

[Read more →]

The Nissan Enhanced OBD II software is included with the Dyno-Scan™ for Windows software. A unique Nissan Enhanced Product Key is purchased to unlock the features. The enhanced upgrade works on 2000 and newer Nissan and Infiniti vehicles1. The enhanced software allows you to:
Read enhanced diagnostic trouble codes (DTCs) from systems like ABS and airbag
Display […]

[Read more →]

1) Disconnect the battery.
2) Open door completely and loosen the door catch that is attached to the inner frame and the door. Later we’ll remove it.
3) Remove fender:
Remove all 6 screws that are attached to the inner fender well.
Remove (2) 10mm bolts that secure the bumper to the fender.
After removing the (2) 10mm bolts you […]

[Read more →]

Before installing the Fuel Cut Defender it is important to determine were the vehicles ECU receives its boost reference signal from the manifold absolute pressure sensor or air flow meter, failure to connect the boost cut defender to the correct sensor could cause severe engine damage. It is advisable to consult the manufacturer service manuals […]

[Read more →]

The Mazda Enhanced OBD II software is included with the Dyno-Scan™ for Windows software. A unique Mazda Enhanced Product Key is purchased to unlock the features. The enhanced software allows you to:
• Read enhanced diagnostic trouble codes (DTCs) from systems like ABS and airbag Display enhanced DTC definitions from Body and Chassis systems
• Turn off […]

[Read more →]

Electronic Climate Control
1. Disconnect the negative battery terminal to prevent an accidental short circuit.
2. Unscrew the shift knob counter clockwise to remove. (Figure A)
3. Unclip and remove the cup holder/parking brake cover and shifter cover as one unit. (Figure B)
4. Remove (2) Phillips screws from the bottom of the radio/climate control panel. (Figure C)
5. Open […]

[Read more →]

1. Unscrew the shift knob and remove the boot.
2. Remove cover which houses the lighter assembly. There are four clips holding it to the center console, they just pop out.
3. Unplug the lighter assembly. Below you can see the cover off and the four clips which hold it to the center console.
4. Remove the two […]

[Read more →]