Automotive Manual, Car Parts and News

RSS Feed

Free PDF Download, Car Parts and Automotive News

How to do a transmission oil change Chevrolet 96 pick up?

January 4th, 2011 · No Comments

I have a 96 chevy pick up truck 1500 and i want to do it a tranny flush. But i don’t know how to drain the oil from the trans?

[Read more →]


How to what year Chevrolet custom deluxe 10 is?

January 3rd, 2011 · No Comments

- Hard to tell without seeing the truck, but the custom deluxe models were from 1970-1980 I think. take down the VIN number, then go to the 67-72 chevrolet trucks.com site(its a forum for all years of chevy and gmc trucks). there you should be able to break down the vin to get the year, [...]

[Read more →]


How to check the fuel pressure on Chevrolet s10?

January 1st, 2011 · No Comments

I have a 99 chevy s 10 with a 4.3 liter v6, it has a throttle body. I need to figure out how to check the fuel pressure and make sure the fuel pump is what is bad.

[Read more →]


HD Standard Length SYE Kit for the NP241

December 6th, 2010 · No Comments

Installation Instructions for the NP241C or NP241DLD Transfer Case. This kit fits for Jeep, Chevy, Dodge.
Applications:
• Use for installing Dodge NP241 into Jeep TJ, YJ, XJ with original Jeep speedometer
• Install in existing Dodge NP241 (truck) with transfer case mounted speedo pickup
• Use for installing Chevy NP241 into Jeep TJ, YJ, XJ requiring Jeep style [...]

[Read more →]


Auto Meter Tach Adapter Installation Instructions

September 18th, 2010 · No Comments

Installation
The Auto Meter Tach Adapter wires inline on the positive 12 volt supply wire. It senses current on the coil positive wire and converts it to a 12 volt signal output. To install the Tach Adapter, the coil positive wire must be identified for your application. Once the wire has been located it is recommended [...]

[Read more →]


83 Chevrolet Citation Ignition Teardown

July 19th, 2010 · No Comments

This time we will teardown a column to make keys for a 1983 Chevy Citation. It is a standard style non-tilt that you find on a lot of the older economy type cars made from the late ‘70s to the ‘90s. Tools needed: ¼ inch socket set, Phillips #2 Screwdriver, 2 small flat screwdrivers (or [...]

[Read more →]


Chevy Bolt Pattern Guide

July 19th, 2010 · No Comments

The bolt pattern, lug pattern, or bolt circle is the diameter of an imaginary circle formed by the centers of the wheel lugs. Bolt patterns can be 4, 5, 6, or 8 lug holes. A bolt circle of 4×100 would indicate a 4 lug pattern on a circle with a diameter of 100mm. The bolt [...]

[Read more →]




?>