Automotive Manual, Car Parts and News

This document provides all the necessary information to allow your Whelen product to be properly and safely installed. Before beginning the installation and/or operation of your new product, the installation technician and operator must read this manual completely. Important information is contained herein that could prevent serious injury or damage.
INSTALLATION:
1. Position the lightbar in the […]

[Read more →]

Installation recommendation: JBA recommends in most cases that the vehicle be taken to a reputable exhaust shop.
For 30-2535 and 50-2535 Only For Super cab/short bed trucks relocate the front muffler hanger to the hole on the side of the frame.
Start:
1. Remove and inventory new JBA exhaust system.
2. Disconnect negative battery cable and allow vehicle to […]

[Read more →]

Read all instructions before starting any work.
1. Remove the O.E. inlet pipe/muffler/tail pipe welded assembly from the vehicle. Lubricate the rubber isolators with WD-40, or a similar product, to aid in removal of the metal rod hangers. Do NOT remove the exhaust pipe just ahead of the welded muffler assembly
2. Install DynoMax inlet pipe […]

[Read more →]

Read all instructions before starting any work.
1. It is suggested to lower or completely remove the spare tire from under the vehicle. This will help in the removal of the original equipment (OE) exhaust system and with the installation of the DynoMax exhaust kit.
2. Remove the existing exhaust system assembly from the vehicle. Lubricate the […]

[Read more →]

The SuperGlide’s Way tubes are coated with SlipPlate at the factory to provide lubrication for ONE TRIP ONLY. The end user will need to continue using the graphite-based lubricant SlipPlate or a medium duty grease on the top and inward facing sides of the way tubes. See Owner’s Manual for complete lubrication instructions.

[Read more →]

1. For ease of installation of your Banks High-Ram Intake, please familiarize yourself with the procedures by reading the entire manual before starting work. This instruction manual contains 8 pages of text, and 6 illustrations.
2. Disconnect the ground cable from the battery before beginning work. If there are two batteries, disconnect both.
3. Route and tie […]

[Read more →]

Never work on a hot exhaust system. Serious injury in the form of burns can result If the vehicle has been in use and the exhaust system is hot, allow vehicle to cool for at least 1 hour. Always wear eye protection when working under any vehicle. Note: It is our recommendation that you use […]

[Read more →]

Removal of original system
1.) start under the hood. locate the turbo. remove the v-clamp from the turbo outlet. loosen the bolt enough to unlatch the t-bolt, then pry the clamp away from the flange at three spots using a flathead screwdriver.
2.) from underneath your vehicle, cut the stock system in two places. first, cut the […]

[Read more →]

KING PIN TRAILER PLATE INSTALLATION:
FOR KING PIN BOXES WITH A FLANGE:
1. Place the Trailer Plate {J2} over the King Pin, with the guide wedge towards the rear of the trailer (wedge facing down). Align the Trailer Plate {J2} square with the king pin box and clamp in place to prevent movement.
2. Mark the holes for […]

[Read more →]

The following instruction should be followed to install the king pin Trailer Plate.
FOR KING PIN BOXES WITH A FLANGE:
1. Place the Capture Plate {J2} over the king pin, with the guide wedge towards the rear of the trailer (wedge facing down). Align the Capture Plate {J2} square with the king pin box and clamp in […]

[Read more →]