Automotive Manual, Car Parts and News

Installation recommendation: JBA recommends in most cases that the vehicle be taken to a reputable exhaust shop.
For 30-2535 and 50-2535 Only For Super cab/short bed trucks relocate the front muffler hanger to the hole on the side of the frame.
Start:
1. Remove and inventory new JBA exhaust system.
2. Disconnect negative battery cable and allow vehicle to […]

[Read more →]

Read all instructions before starting any work.
1. Remove the O.E. inlet pipe/muffler/tail pipe welded assembly from the vehicle. Lubricate the rubber isolators with WD-40, or a similar product, to aid in removal of the metal rod hangers. Do NOT remove the exhaust pipe just ahead of the welded muffler assembly
2. Install DynoMax inlet pipe […]

[Read more →]

TO START:
1. Remove and inventory JBA exhaust
2. Disconnect negative battery cable and allow vehicle exhaust to cool.
3. With the vehicle raised and properly supported, use a 15mm socket to remove the bolts that attach the exhaust system to the Catalytic converter.
4. Using a pry bar or a pair of channel lock pliers, remove hangers from […]

[Read more →]

- Complete Stock Intake.
- With 5/16” nut driver loosen clamps on OE tube at turbo/air box and remove. Loosen clamp at turbo and disconnect crank case line with pliers. Remove tube.
- Disconnect air temp & MAF sensor. Loosen 10mm nut holding in front of air box using wrench or socket. Lift up and pull OE […]

[Read more →]

TO START:
1. Remove and inventory JBA exhaust
2. Disconnect negative battery cable and allow vehicle exhaust to cool.
3. With the vehicle raised and properly supported, using the 15mm socket and ratchet, loosen the clamp, at the rear of the muffler, that secures the tail pipe to the muffler.
4. Spray lubricant on the exhaust pipe behind the […]

[Read more →]

Module Installation
1. The Edge EZ Module can mount on the flat black plastic fuse box cover located on the driver’s side fender. Adhere the module using the supplied velcro, allowing enough harness movement for removal of the cover.
Data Link Connection
2. The Data Link connector is located in different locations based on the year of the […]

[Read more →]

Complete Stock passenger side intake. Please disconnect battery terminals before installation.
With 10mm socket or wrench, loosen the 2 bolts holding in lower engine cover and remove.
Disconnect MAF sensor harness. With 10mm socket or wrench loosen bolt holding in air box.
Loosen clamps on intake using 5/16” nut driver.
With pliers pull back crank case line from intake.
Remove […]

[Read more →]

Disconnect the negative battery terminal before starting this installation.
1. Remove the air intake duct, the air intake box and the air vacuum lines connected to the air box. Unbolt the air mass sensor from the air box and set aside at this point. This installation also requires removal of the front bumper and the air […]

[Read more →]

Top Rail assembly:
Please note. Top rail will not be required if a tent is to be installed on roof rack.
1. Slide 5 of 6*12mm bolts into the channel on the top of the tubing on the sides on the rack. The very first one, slide all the way forward - this will be used to […]

[Read more →]

Read all instructions before starting any work.
1. Remove the O.E. exhaust from the flanged connections behind the catalytic converters. Lubricate the rubber isolators with WD-40, or a similar product, to aid in removal of the metal rod hangers.
2. Install DynoMax RH y-pipe 52312 and LH cross-over pipe 52313. Insert the metal rod hanger on 52312 […]

[Read more →]