Pillar installation Directions: Read directions before starting installation Model# (17212 Dual), (17213 Triple) Fits 03+ Dodge Ram
1) Remove Stock Pillar by removing the two screws located under the caps of pillar handle.
2) Install Gauges in new pillar.
3) Tape or secure gauge wiring to back of pillar.
4) Install new pillar in place of old pillar.
5) Use provided screw to hold pillar in place:
• Make sure screw is aligned with factory hole to avoid cross threading
• Don’t over tighten screw.
Dodge Ram Pillar Installation Instructions
January 10th, 2010 · No Comments
05-07 Nissan Titan Crew Cab/Ext. Cab Oval Side Bar Installation
November 21st, 2009 · No Comments
PROCEDURE
1. Begin installation by working on driver side of the vehicle starting at the front of the inner rocker panel.
2. Located on the inside as well as the bottom inner of the rocker panel you will see one thread hole and one thread stud for each mounting bracket refer to diagram 1. (Note all brackets […]
Search engine terms: 2006 dodge ram A pillar pod and gauges, , Remove two screws at bottom of panel 2 Remove plastic trim by pulling from the front end, , gauge installation dodge, dodge ram pillar gauge kit, take off pillars f150, pillar post gauge for dodge challenger, , wiring gauge pillar dodge, Mazda remove a-pillar cover airbag, auto gauge instruction, gauge pillar dodge installing, pillar mounting instructions, how to wire cummins gauges, 2009 challenger pillar gauges, removal dodge towing mirror ram, wiring transmission gauge on dodge, 2010 dodge pillar pod, wiring a two pillar car jack,
