Automotive Manual, Car Parts and News

1. Disconnect the negative battery cable, and remove the factory “accordion” style intake hose by loosening the two factory clamps.
2. Loosen the two 10mm bolts securing the factory air box to the intake manifold.
3. Disconnect the air temperature sensor wire on the front of the factory air box & twist to remove the sensor from […]

[Read more →]

- Complete Stock Intake.
- With 5/16” nut driver loosen clamps on OE tube at turbo/air box and remove. Loosen clamp at turbo and disconnect crank case line with pliers. Remove tube.
- Disconnect air temp & MAF sensor. Loosen 10mm nut holding in front of air box using wrench or socket. Lift up and pull OE […]

[Read more →]

Removing the stock air inlet system
a) Before removing any of the O.E. components, label each individual part so that no components become mixed up during the installation process.
b) Stock air system
c) Unplug the Inlet Air Temperature Sensor (IAT) from the stock resonator box
d) Remove the breather hose from the plastic tee (Vehicles equiped with plastic […]

[Read more →]

This inlet pipe kit requires the removal and reinstallation of emissions related components. If you are not familiar with the installation and/or the operation of these components then please refer this installation to a qualified professional.
Installing the Short Ram Air Intake System
a) When installing the AEM Air Intake System, DO NOT completely tighten the hose […]

[Read more →]

Installing the Short Ram Air Intake System
a) When installing the Short Ram Air Intake System, DO NOT completely tighten the hose clamps or mounting tab hardware until instructed to do so later in these instructions.
b) Check to see that the inside of the AEM inlet pipe and air filter are clean and free from any […]

[Read more →]

FITTING YOUR BOV 300ZX ADAPTOR
Note: Please thoroughly read and understand both these instructions and the fitting instructions supplied with your BOV before commencing this installation.
Step 1. Locate the two boost hoses.
Step 2. Loosen the factory hose clamps securing the boost hoses to the intercooler pipe and throttle body.
Step 3. Loosen the factory hose clamps securing […]

[Read more →]

1) Remove front engine mount upper bolt with 14mm socket. The front engine mount is located on the timing cover side of the engine also known as the front of the engine.
2) Install the small torque link bracket as shown in picture. Use supplied M10 bolt and tighten to finger tight. A 13mm wrench or […]

[Read more →]

1. Cold air shown. Kit can also be short ram.
2. Complete Stock intake. Please disconnect battery terminals before installation.
3. Disconnect MAF sensor harness. Unclip upper half of air box. Loosen clamps using 10mm socket or wrench.
4. Remove crank case line.
5. Remove stock intake tube and upper air box.
6. With 10mm socket or wrench loosen bolt […]

[Read more →]

Installation of the AEM Short Ram Intake System.
a) When installing the Short Ram Intake System, DO NOT completely tighten the hose clamps or mounting tab hardware until instructed to do so later in these instructions.
b. Install the supplied 1.75” to 2.25” reducing elbow onto turbo inlet with pipe and clamps as shown.
c. Assemble the supplied […]

[Read more →]