Automotive Manual, Car Parts and News

With the wide range of variations found on the Flathead Ford Engine, it is impossible to cover all specific installations. This Installation Manual is intended only to be a basic guide, and will require you to use your own mechanical know-how and think for yourself. Remove Manifold, Distributor, Front Cover, Water Pumps, Crank Pulley and— [...]

[Read more →]

1. It is highly recommended that an oil and filter change be done before installing new cams.
2. Remove the ignition coils, valve cover and sprocket cover from the engine. Use caution not to drop anything into the engine. Note the O-ring between the sprocket cover and the front cover, be sure it is but back [...]

[Read more →]

I have a 1965 Chevy p/up that has been ‘enhanced’ with a 283 V8 and a four speed transmission. It has this rather large device on that front of the crankshaft that I have been told is a harmonic balancer – so far, so good. Just one problem. I have no idea what a harmonic [...]

[Read more →]

Oil leak is a problem at our vehicle, 1994 GMC models include several engine sizes, based on whether the model is a Sierra or a Jimmy. Finding where oil is leaking is a similar process among all the engine types. The size of the engine and the location of cooling system parts are the main [...]

[Read more →]

The Opel ignition timing is designed to be set at TDC (Top Dead Center). Adjustments are made to the point gap (.018” on most), and operation is checked at idle with a dwell Meter. Dwell is to be set to 50 degrees +or- 2 degrees. This test is to be performed with the distributor vacuum [...]

[Read more →]

This manual is intended for the installation of Powerdyne Supercharger kit, Part Number K10407-101 and K10410-101 on Ford F-150 and Expedition with the 4.7L and 5.4 liter motor, model years 1997-2000. This kit is designed to be 50 state smog legal and as of the writing of this manual C.A.R.B. (California Air Resources Board) exemption [...]

[Read more →]

This manual is intended for the installation of the Powerdyne Supercharger kit, Part Number K10513 on the Dodge 318 or 360 C.I. motors, model years 1999-2000 This kit is designed to be 50 state smog legal and as of the writing of this manual C.A.R.B. (California Air Resources Board) exemption is pending. This kit already [...]

[Read more →]

1. It is highly recommended that an oil and filter change be done before installing new cams.
2. Remove the distributor, and valve cover from the engine. Use caution not to drop anything into the engine.
3. With the parking brake on, and the car out of gear (neutral), rotate the crankshaft clockwise until #1 cylinder is [...]

[Read more →]

1. It is highly recommended that an oil and filter change be done before installing new cams.
2. Remove the plug wires, and valve cover from the engine. Use caution not to drop anything into the engine.
3. With the parking brake on, and the car out of gear (neutral), rotate the crankshaft clockwise until #1 cylinder [...]

[Read more →]