Automotive Manual, Car Parts and News

Remove air cleaner assembly.
a) Disconnect air tube from air box.
b) Remove air box lid and filter.
c) Remove air cleaner assembly from fender. Loosen nut at rear near washer reservoir. Remove plastic stud from filter box snout, then remove assembly from vehicle.

[Read more →]

1. Flip up headlights (use dash switch, not column lever)
2. Disconnect and remove battery, battery box (2X 10mm hex), and battery shelf (3X 10mm hex)
3. Remove covers (black) from around the headlights (phillips head screwdriver)
4. Remove intake duct and air box (OEM)
5. Remove intercooler (move AST to the side, no need to disconnect)
6. Remove intercooler […]

[Read more →]

The Mazda Enhanced OBD II software is included with the Dyno-Scan™ for Windows software. A unique Mazda Enhanced Product Key is purchased to unlock the features. The enhanced software allows you to:
• Read enhanced diagnostic trouble codes (DTCs) from systems like ABS and airbag Display enhanced DTC definitions from Body and Chassis systems
• Turn off […]

[Read more →]

Before proceeding with the installation, it is important to know that to validate the 2 year, 100K warranty on your new J/R supercharger, you must completely fill out the Moss Motors / Jackson Racing warranty card that comes in every kit, including serial number which is on a small white ‘bar code’ label on the […]

[Read more →]

- Remove the clamp (1) securing the crossover tube to the AFM
- Remove the clamp (2) securing the air snorkel to the air box.
- Unplug the AFM connector (3) by pushing down on the tab and pulling away. Do not pull on the wires.
- Remove the two 12 mm bolts (4 & 5) securing the […]

[Read more →]

INSTALLATION PREPARATION:
1. DISCONNECT NEGATIVE BATTERY CABLE BEFORE INSTALLATION.
2. REMOVE THE STEERING COLUMN SHROUD AND LOWER DASH PANEL.
HARNESS INSTALLATION:
1. LOCATE THE WHITE CONNECTOR AT THE IGNITION SWITCH. CONNECT THE RED IGNITION WIRE (+12V IGNITION) FROM THE MAIN CRUISE HARNESS TO THE GREEN/RED WIRE OF THE IGNITION SWITCH CONNECTOR.
2. LOCATE THE YELLOW 12-PIN CLOCK SPRING CONNECTOR AT […]

[Read more →]

On a vehicle with an automatic transmission, see Fig. 1 for a schematic of the engine wiring between the PLD control unit and the bulkhead connector. For a detailed (partial) schematic of the wiring to the transmission electronic control unit (ECU), main power distribution module (PDM), engine fan, low coolant probe, and intake-air heater (optional), […]

[Read more →]

The throttle is simultaneously linked by cable to the cruise control actuator and by a second cable to the accelerator pedal. The core of the cruise control actuator is a small motorized drum which winds or unwinds a belt of rubberized fabric. This control belt is affixed to the cable connected to the throttle. Thus, […]

[Read more →]

The information presented in this manual has been carefully compiled through actual vehicle testing and manufacturers service manual research and to the best of our ability is accurate. However, we do not warrant the accuracy of this information against changes in vehicle design, the use or misuse of this information or typographical errors. It is […]

[Read more →]

The passion and style of Lexus has been reborn in a line of vehicles that promise both remarkable beauty and pure performance. From the very first glance, the Lexus GS reveals itself as a dynamic yet graceful vehicle with a true performance edge. The GS line represents four dynamic expressions of luxury infused with passionate […]

[Read more →]