Automotive Manual, Car Parts and News

Wiring
Disconnect Ground (Negative) terminals on all vehicle batteries before starting installation. The following instructions will be divided up for wiring up each individual wire color labeled on the Co-Pilot. Follow along with the diagrams after the written instructions for ease of installation. Solder all connections for reliable results. These wire connections must be shielded from […]

[Read more →]

The following information describes the installation procedure for the M-11572-GT “ENGINE START” push-button
into a 2005-‘09 Mustang.
STEP 1: Start by removing the (2) screws found at the rear of the center console underneath the armrest.
STEP 2: Remove the trim plate which surrounds the Shifter Handle (Auto) or Shifter Boot (Manual).
Note: Manual transmission applications will require removing […]

[Read more →]

Diesel Turbo Lifesaver (DTLS) is a computer controlled device that allows you to set an automatic engine idle sequence to properly cool your turbocharger before engine shutdown as required by Ford and Navistar. Failure to follow recommended turbo cooling procedures can lead to premature bearing failure that is NOT covered under the factory warranty. Installing […]

[Read more →]

1. Remove stock dash panel by snapping it off the dash. See the shop manual for more information.
2. Remove small storage pocket from lowest position on panel. (Some vehicles may have seat warmer, shift on the fly, etc. switches installed in this position. The switches will have to be relocated to install the dash pod.) […]

[Read more →]

To original Nissan radio is mounted to a center dash assembly which contains not only the radio but air conditioner controls, and two pockets below the radio. When replacing the radio, this entire assembly must be removed first, then the Nissan radio can be unscrewed and removed and a new replacement radio can be installed.

[Read more →]

STEP 1. Begin by inserting hook tool at very back of trim panel surrounding gear shift selector. Release two (2) clips at the rear and continue towards front of panel to release two (2) more clips. CAUTION! These parts are plastic and this panel comes out extremely hard.
STEP 2. Remove ashtray by removing screw on […]

[Read more →]

INSTALLATION PREPARATION:
1. DISCONNECT NEGATIVE BATTERY CABLE BEFORE INSTALLATION.
2. REMOVE THE STEERING COLUMN SHROUD AND LOWER DASH PANEL.
HARNESS INSTALLATION:
1. LOCATE THE WHITE CONNECTOR AT THE IGNITION SWITCH. CONNECT THE RED IGNITION WIRE (+12V IGNITION) FROM THE MAIN CRUISE HARNESS TO THE GREEN/RED WIRE OF THE IGNITION SWITCH CONNECTOR.
2. LOCATE THE YELLOW 12-PIN CLOCK SPRING CONNECTOR AT […]

[Read more →]

STEP 1. Set the emergency brake. Insert key into shift lock mechanism. With vehicle ignition off, put vehicle into gear. Remove ash tray by pressing on its face. It will pop open. Push down on lip located on top of ash tray. Ash tray will rotate out. Set aside. Next, remove the trim panel surrounding […]

[Read more →]