Automotive Manual, Car Parts and News

These components are designed to improve the exhaust efficiency of the Dodge 3.9 Litre V6 engine with E.F.I. (Electronic Fuel Injection). These tubular manifolds are a direct replacement for the factory exhaust manifolds. A performance gain can be expected by the installation of this system. This system does not require welding for installation and retains […]

[Read more →]

TO START:
1. Remove and inventory JBA exhaust.
2. Disconnect negative battery cable and allow vehicle exhaust to cool.
3. With the vehicle raised and properly supported, spray lubricant on all rubber isolators. Using the pry bar, remove rubber isolators from muffler hangers.
4. Remove the factory exhaust clamp located directly behind the catalytic converter.
5. Remove the tail pipe […]

[Read more →]

This coil spring lift kit should only be installed on vehi- cles in good working condition. Before installation, the vehicle should be thoroughly inspected for evidence of corrosion or deformation. This coil lift kit should not be installed on any vehicle that is suspected to have been in a collision or misused. Failure to observe […]

[Read more →]

Ride Height
1. Measure ride height with the vehicle supporting its own weight on level ground. To settle the suspension, the vehicle should be driven forward at least 10 feet immediately prior to taking these measurements. Ride height is the measurement from the center of the axle straight up (vertical) to the fender lip. Record this […]

[Read more →]

Removing the stock air inlet system
a) Before removing any of the O.E. components, label each individual part so that no components become mixed up during the installation process.
b) Stock air system
c) Unplug the Inlet Air Temperature Sensor (IAT) from the stock resonator box
d) Remove the breather hose from the plastic tee (Vehicles equiped with plastic […]

[Read more →]

Remove air cleaner assembly.
a) Disconnect air tube from air box.
b) Remove air box lid and filter.
c) Remove air cleaner assembly from fender. Loosen nut at rear near washer reservoir. Remove plastic stud from filter box snout, then remove assembly from vehicle.

[Read more →]

To inform Chrysler vehicle owners about Chrysler Technical Service Bulletin TSB 09-05-00 (1). The Chrysler Bulletin describes the replacement of the engine intake manifold plenum pan gasket. If the ple- num gasket leaks, it may disrupt the performance and service life of the motor oil.
The Chrysler TSB 09-05-00 noted two symptoms of a plenum gasket […]

[Read more →]