Automotive Manual, Car Parts and News

All hardware should be tightened only enough to ensure safety during assembly. Fully tighten all hardware after entire assembly is completed.
1. Remove the plastic air dam from the bottom of the front bumper. The air dam cannot be reinstalled when this mount kit is on the truck and should be returned to the vehicle owner […]

[Read more →]

Pillar installation Directions: Read directions before starting installation Model# (17212 Dual), (17213 Triple) Fits 03+ Dodge Ram
1)  Remove Stock Pillar by removing the two  screws located under the caps of pillar handle.
2)  Install Gauges in new pillar.
3)  Tape or secure gauge wiring to back of pillar.
4)  Install new pillar in place of old pillar.
5)  Use provided screw to hold pillar in place:
•  Make sure screw is aligned with factory hole to avoid cross threading
•  Don’t over tighten screw.

[Read more →]

1. Remove tailgate by disconnecting the tether cable and lifting the tailgate out at approximately a 45º angle. (Reference the truck’s Owner’s manual).
2. Carefully remove the OEM tailgate pivot cup from the tailgate taking note of which side they belong on.
3. Remove latch pin bolt. A special wrench may be required.
4. Figures 1 through 5 […]

[Read more →]

List of tools and additional parts required
Masking tape, clear tape, black mastic, hammer, centre punch
Assorted screw drivers, sockets and spanners 103mm (4”) hole saw
Assorted drill set, wet / dry sand paper, ½ round file, small square file, Zinc rich primer.

[Read more →]

1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm socket.
5. Remove the oil filler cap (for clearance if needed) and […]

[Read more →]

Installation requires a professional mechanic. Prior to beginning, inspect the vehicles steering, driveline, and brake systems, paying close attention to the suspension link arms and bushings, stabilizer bars and bushings, tie rod ends, pitman arm, ball joints and wheel bearings. The overall vehicle must be in excellent working condition; repair or replace all worn parts. […]

[Read more →]

1. Remove stock dash panel by snapping it off the dash. See the shop manual for more information.
2. Remove small storage pocket from lowest position on panel. (Some vehicles may have seat warmer, shift on the fly, etc. switches installed in this position. The switches will have to be relocated to install the dash pod.) […]

[Read more →]

1. Disconnect the negative battery cable, and remove the factory “accordion” style intake hose by loosening the two factory clamps.
2. Loosen the two 10mm bolts securing the factory air box to the intake manifold.
3. Disconnect the air temperature sensor wire on the front of the factory air box & twist to remove the sensor from […]

[Read more →]

- Complete Stock Intake.
- With 5/16” nut driver loosen clamps on OE tube at turbo/air box and remove. Loosen clamp at turbo and disconnect crank case line with pliers. Remove tube.
- Disconnect air temp & MAF sensor. Loosen 10mm nut holding in front of air box using wrench or socket. Lift up and pull OE […]

[Read more →]

Proper installation of this kit requires knowledge of the factory recommended procedures for removal and installation of original equipment components. We recommend that the factory shop manual and any special tools needed to service your vehicle be on hand during the installation. Installation of this kit without proper knowledge of the factory recommended procedures may […]

[Read more →]