Automotive Manual, Car Parts and News

1. Turn off the ignition and disconnect the negative battery cable.
2. Loosen the hose clamp at the intake resonator as shown.
NOTE: Disconnecting the negative battery cable erases pre-programmed electronic memories. Write down all memory settings before disconnecting the negative battery cable. Some radios will require an anti-theft coded to be entered after the battery is […]

[Read more →]

Step 1: Prior to lifting the vehicle it is recommended that you measure the stock height of the vehicle so that you have a base line to gauge the height of the vehicle. Measure the vehicle from the bottom of the wheel to the lip of the fender. Position truck on a flat surface and […]

[Read more →]

Never work on a hot exhaust system. Serious injury in the form of burns can result If the vehicle has been in use and the exhaust system is hot, allow vehicle to cool for at least 1 hour. Always wear eye protection when working under any vehicle. Note: It is our recommendation that you use […]

[Read more →]

Install Paint Protection Film before mud guards (see other side)
Please read instructions thoroughly before installation.
1. Clean and degrease the mud guard location area on the fender before installation.
2. Remove factory fastener from location B and attach mud guard to fender with factory fastener (Figure 1).
3. Using the mud guard as a template, mark and drill […]

[Read more →]

Step 1: Prior to lifting the vehicle it is recommended that you measure the stock height so that you have a base line measurement. Measure from the bottom of the wheel to the lip of the fender, as in Insert A. Position truck on a flat surface and lift vehicle by the frame so that […]

[Read more →]

Although this hitch is designed to safely tow its rated load, we recommend that you consult your vehicle owner’s manual for possible manufacturer’s recommendations or limitations. Always follow the manufacturer’s installation instructions and always install on the specified vehicle. Before installing hitch, check that the attachment points are in good condition. Failure to follow these […]

[Read more →]

The net amount of ride height increase depends upon the age and use of the vehicle, wheel offset, and numerous other factors. Stated torsion bar ride height in- creases are based upon factory specifications. If the torsion bars were “cranked up” at some point in the past, expect a corresponding reduction in overall height increase […]

[Read more →]

FRONT OF VEHICLE
1. Park vehicle on level concrete surface.
2. Center and lock the steering wheel.
3. Block the rear wheels of the vehicle to prevent vehicle from moving in either direction.
4. Remove the upper track bar bolt using an 18mm socket and save bolt for later reinstall. See Figure A.
5. Remove the lower front shock bolts […]

[Read more →]

Step 1: (A) Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground using a floor jack and jack stands or a (2) two post lift if available. Next locate the torsion key at the rear of the torsion bar under the cab of […]

[Read more →]

1) Front brackets are identical and are simply turned 180 degrees out so face of bracket is facing outside of truck.
2) Bars can be mounted either side and are identical.
3) Body mount torque is 65 ft.-lbs.
4) Holes in rocker panel are usually covered with black or grey tape from manufacturer

[Read more →]