Automotive Manual, Car Parts and News

For easier assembly and installation, vehicle and all snowplow components should be on a smooth, level, hard surface, such as concrete.
1. Remove license plate bracket and retain for vehicle owner. Remove bumper from bumper brackets. Retain fasteners.
2. Remove bumper brackets from frame. Retain fasteners.
Diesel applications: On these applications, you must first remove the top two […]

[Read more →]

Removal of Stock System:
1. Separate the stock exhaust system at the slip joint by the muffler. Remove the rear exhaust from rubber hangers and remove the system from under the truck.
2. Using a 15mm socket or wrench, remove the two (2) bolts at the turbo flange and remove the stock down pipe.
Installing Your Front Section […]

[Read more →]

1. Remove the bumper and adjustable bumper mount plates from the truck frame rail. NOTE: The fascia will need to be permanently removed or notched for reinstallation. Discard mount plate hardware.
2. Install the support arms (Ref 8 & 9) to the truck frame rail. The passenger side will install behind the front stabilizer bar and […]

[Read more →]

For easier assembly and installation, vehicle and all snowplow components should be on a smooth, level, hard surface, such as concrete.
1. Remove bumper from bumper brackets. Retain fasteners.
2. Remove bumper brackets from frame. Diesel and V10 applications: On these applications you must first remove the top two intercooler fasteners. Then push intercooler up and out […]

[Read more →]

Step Description
1. Place the vehicle on a hoist that leaves the entire underside of the frame.
2. Drain all the fuel from the original equipment tank using a pump or siphon. In some cases Dodge tanks have a screen at the tank inlet which won’t allow a siphon hose to enter. In this case, it may […]

[Read more →]

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the air temp. sensor electrical connection.
3. Loosen the hose clamps at the turbo inlet and the airbox outlet as shown.
4. Remove the intake tube from the vehicle as shown.
5. Loosen and remove the 10mm nut that retains the airbox to the […]

[Read more →]