Automotive Manual, Car Parts and News

Tools required for the installation are: 7/16″, 5 mm & 9/32″ sockets, a small screw driver, electrical tape and a sharp tool for cutting a hole for the in/out switch. Model 8005TK will also require a volt meter.
REMOVAL OF EXISTING MIRROR:
1. Remove the trim panel on both doors (note - Ford doors do not have […]

[Read more →]

Procedure: (Approximate time to complete installation: 3 - 4 hours)
A. Removing the Door Panel Coverings
1. For ease of installation, do both sides at the same time.
2. Roll the windows to approximately 1/2 open, and so the crank handle is in the Down Position. With either the Crank Spring Removal Tool, or a flat Screwdriver, remove […]

[Read more →]

Do not attempt to manually extend or retract the mirrors. They should be moved under their motor power only!
Tools required for the installation are: 10mm deep socket, a 10mm open end wrench, trim panel remover, Philips screwdriver, razor knife, and torque inch pound wrench. For model 7005TK, a volt meter will be necessary. If you […]

[Read more →]