Automotive Manual, Car Parts and News

The JackRabbit is designed to carry rainwater from the cover into the canister and then out through the drains. Most truck models have standard OE drain holes or plastic/rubber access ports in the front of the truck bed. Check to make sure your truck has the OE drain holes so that drilling into the sheet […]

[Read more →]

Step 1 - Unpack QuickLIFT kit and verify contents.
Remove all items from the packing tube. You should have the following before beginning:
* (2) Gas Springs - Be sure to cycle them a few times before installing!
* (4) 3/16″ gold shafted rivets - for hood brackets
* (2) 3/16″ Multi-grip rivets - center hole of hood brackets
* […]

[Read more →]

The JackRabbit is designed to carry rainwater from the cover into the canister and then out through the drains. Most truck models have standard OE drain holes or plastic/rubber access ports in the front of the truck bed. Check to make sure your truck has the OE drain holes so that drilling into the sheet […]

[Read more →]

TOOLS REQUIRED: #2 Phillips screwdriver, hook tool, 9/32” & 5/16” sockets & driver, telescopic magnet, 5/64” drill bit and drill, protective cloth, marking pen.
PARTS INCLUDED: Pro.Fit VSMTM , instructions, two (2) # 10x 5/8” screws.
LOCATION: To the right of the radio
STEP 1. Begin by removing the simulated wood grain bezel that surrounds the ashtray. Insert […]

[Read more →]

Before Starting Installation
1. Carefully read all warnings and instructions completely before beginning.
2. Verify all parts have been received in this kit by checking the parts list at the end of this document.
3. Only install this kit on the vehicle for which it is specified. If anytime during the installation you encounter something different from what […]

[Read more →]

When assembling the transmission to the transfer case, DO NOT FORCE the two gear boxes together. If the shaft is too long, there is the possibility of pre-loading the transmission bearings for premature failure. Take the extra time to make sure that the shafts do not bottom out internally. If there is an interference problem, […]

[Read more →]

PLEASE READ COMPLETE INSTRUCTIONS BEFORE INSTALLING THIS Pro.Fit MOUNT. All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break
STEP 1.
Begin by removing trim bezel that surrounds climate control. Insert hook […]

[Read more →]

STEP 1. Open up the power outlet door and locate and remove one (1) Phillips head screw using your # 2 Phillips screwdriver . Set screw aside. Open up both the cup holder door and the ashtray door. Remove the dash trim bezel that surrounds the radio and climate control and extends across the instrument […]

[Read more →]

The Roll-Top-Cover® is designed to carry rainwater from the cover into the canister and then out through the drains. Most truck models have standard OE drain holes or plastic/rubber access ports in the front of the truck bed. Check to make sure your truck has the OE drain holes so that drilling into the sheet […]

[Read more →]

STEP 1. Begin by removing the air vent assembly above the climate control module. There are three (3) clips on the top and four (4) clips on the bottom of the vent. (See photo # 3.) Slide your hook tool between the vent assembly and dash. Push the clip towards the vent to release it, […]

[Read more →]