Automotive Manual, Car Parts and News

RSS Feed

Free PDF Download, Car Parts and Automotive News

Opel Zafira II E48 Towbar Fitting Instructions

September 25th, 2010 · No Comments

This towbar is designed to assembly in following cars: OPEL ZAFIRA II, produced since 2005, catalogue number E48 and is prepared to tow trailers max total weight 1650 kg and max vertical mass 75 kg.
The instruction of the assembly
1. Disassemble a bumper and metal cover. (Note! Metal cover will not reinstall).
2. In rear part, in [...]

[Read more →]


Dodge Bracket SuperRail Installation Instructions

December 8th, 2009 · No Comments

KING PIN TRAILER PLATE INSTALLATION:
FOR KING PIN BOXES WITH A FLANGE:
1. Place the Trailer Plate {J2} over the King Pin, with the guide wedge towards the rear of the trailer (wedge facing down). Align the Trailer Plate {J2} square with the king pin box and clamp in place to prevent movement.
2. Mark the holes for [...]

[Read more →]


1995-02 Dodge w/ 6′ SuperRail Installation Instructions

November 29th, 2009 · No Comments

The following instruction should be followed to install the king pin Trailer Plate.
FOR KING PIN BOXES WITH A FLANGE:
1. Place the Capture Plate {J2} over the king pin, with the guide wedge towards the rear of the trailer (wedge facing down). Align the Capture Plate {J2} square with the king pin box and clamp in [...]

[Read more →]


2004-Up Nissan Titan King Cab AMP Research Power Step by Bestop Installation

November 18th, 2009 · No Comments

Power Step – Installation Instructions
1. Drill Holes for Arms
Locate the Drill Template in the parts kit. Place it along the sill under the vehicle. Slide the upper front hole in the template over the stud in the sill and install an 8mm Nut over the stud. Then install a Medium Socket Head Bolt in the [...]

[Read more →]


2004-2008 Nissan Titan SuperRail Mounting Kit Installation Instructions

November 15th, 2009 · No Comments

Truck Preparation
1. Check part quantities using the Parts List on Page 2.
2. Block vehicle wheels. Some vehicles may require you to raise the rear of the truck in order to make it easier to drill for installing the mounting brackets on the truck frame.
3. You may wish to remove the wheels to give yourself greater [...]

[Read more →]


2006 Mazda MX-5 Cargo Net Installation Instructions

October 26th, 2009 · No Comments

Installing Hardware
1. Open lift gate.
2. Locate the two mounting location as indicated by the arrows.
3. On driver’s side, position drilling template, align the edges and tape in place.
4. Using a punch, mark the location for drilling. Remove paper template, ensure the hole is punched through, flip over paper template and repeat on passenger side.
Note: Use [...]

[Read more →]


2003 Mitsubishi Eclipse Spyder GTS BX1964 Installation Instructions

October 1st, 2009 · No Comments

The headlight assembly, front fascia and horn bracket are removed for baseplate installation. Drilling is required. Trimming of air dam and fascia are required. The BX8869 is available for the vehicle. Attachment Tabs are 23 inches center to center and a height of 12 inches.
1. Using the 10MM socket, remove the five metric bolts from [...]

[Read more →]




?>