Automotive Manual, Car Parts and News

1. Turn off the ignition and disconnect the negative battery cable.
2. Disconnect mass air sensor electrical connection.
3. Rotate crank case vent hose locking ring and pull crank case vent hose off of air filter housing. Un-hook wiring harness retaining clip from air box.
3a. Disconnect the brake booster vent line from the air filter housing as […]

[Read more →]

1. Turn off the ignition and disconnect the negative battery cable. NOTE: Disconnecting the negative battery cable erases pre-programmed electronic memories. Write down all memory settings before disconnecting the negative battery cable. Some radios will require an anti-theft coded to be entered after the battery is reconnected. The anti-theft code is typically supplied with your […]

[Read more →]

To Start the installation:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Unlock the red locking tab on the air temperature sensor electrical connection, then depress the locking lever and pull apart the temperature sensor electrical connection
3. Loosen the hose clamp that secures the intake tube to the throttle body and pull […]

[Read more →]

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the air temp. sensor electrical connection.
3. Loosen the hose clamps at the turbo inlet and the airbox outlet as shown.
4. Remove the intake tube from the vehicle as shown.
5. Loosen and remove the 10mm nut that retains the airbox to the […]

[Read more →]

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the mass air sensor electrical connection and unhook the harness from the air box.
3. Remove the two bolts shown, which secure the engine cover.
4. Lift firmly on the engine cover to dislodge it from the mounting grommets, and then remove the […]

[Read more →]

Removing the stock air inlet system
a) Stock intake system.
b) Free differential breather hose from inlet tube, if equipped. Use a supplied zip tie to secure the hose to the brake booster tube.
c) Pull the crankcase breather hose from the valve cover.
d) Loosen the two hose clamps on the ends of the inlet pipe. Remove the […]

[Read more →]