Automotive Manual, Car Parts and News

1. Turn off the ignition and disconnect the negative battery cable.
2. Disconnect mass air sensor electrical connection.
3. Rotate crank case vent hose locking ring and pull crank case vent hose off of air filter housing. Un-hook wiring harness retaining clip from air box.
3a. Disconnect the brake booster vent line from the air filter housing as […]

[Read more →]

1. Turn off the ignition and disconnect the negative battery cable.
2. Loosen the hose clamp at the intake resonator as shown.
NOTE: Disconnecting the negative battery cable erases pre-programmed electronic memories. Write down all memory settings before disconnecting the negative battery cable. Some radios will require an anti-theft coded to be entered after the battery is […]

[Read more →]

To Start the installation:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Unlock the red locking tab on the air temperature sensor electrical connection, then depress the locking lever and pull apart the temperature sensor electrical connection
3. Loosen the hose clamp that secures the intake tube to the throttle body and pull […]

[Read more →]

Step Description
1. Place the vehicle on a hoist that leaves the entire underside of the frame.
2. Drain all the fuel from the original equipment tank using a pump or siphon. In some cases Dodge tanks have a screen at the tank inlet which won’t allow a siphon hose to enter. In this case, it may […]

[Read more →]

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the air temp. sensor electrical connection.
3. Loosen the hose clamps at the turbo inlet and the airbox outlet as shown.
4. Remove the intake tube from the vehicle as shown.
5. Loosen and remove the 10mm nut that retains the airbox to the […]

[Read more →]

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the mass air sensor electrical connection and unhook the harness from the air box.
3. Remove the two bolts shown, which secure the engine cover.
4. Lift firmly on the engine cover to dislodge it from the mounting grommets, and then remove the […]

[Read more →]

1. Turn off the ignition and disconnect the negative battery cable.
NOTE: Disconnecting the negative battery cable erases pre-programmed electronic memories.
Write down all memory settings before disconnecting the negative battery cable. Some radios will require an anti-theft coded to be entered after the battery is reconnected. The anti-theft code is typically supplied with your owner’s manual. […]

[Read more →]

1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the mass air sensor electrical connection.
3. Loosen the hose clamps on the intake hose at the throttle body and mass air sensor.
4. Using a 10mm socket, loosen and remove the bolt that holds the vacuum switch to the airbox lid.
5. Release the […]

[Read more →]

The K&N Dry-Charger included with this kit must be installed on the K&N Air Filter when used with this K&N Typhoon Cold Air Intake System. The K&N Typhoon Intake System is a performance product that can be used safely during mild weather conditions. During harsh and inclement weather conditions, you must convert your Cold Air […]

[Read more →]

Mercury is a toxic metal, often used to activate convenience lighting in the hood or trunk of a car. The mercury in vehicle switches can be released into the environment when a vehicle is crushed or shredded or when scrap metal from a vehicle is recycled by steel mills. Although the amount of mercury used […]

[Read more →]