Automotive Manual, Car Parts and News

Make sure you park the vehicle on a level concrete or asphalt surface. Many times a vehicle is uneven (side-to-side) from the factory, but usually not noticed until a lift kit has been installed which makes the difference more visible. Using a measuring tape, measure the front and rear (both sides) from the ground up […]

[Read more →]

A correct installation must result in the suspension and axle being “loaded” within the range specified by axle and suspension manufacturers. Please check vehicle specifications and intended usage to insure axle will be within Gross Axle Weight Rating (GAWR). No alteration of any suspension component is permitted. Link Mfg. Is not responsible for damages from […]

[Read more →]

The following information describes the installation procedure for the M-11572-GT “ENGINE START” push-button
into a 2005-‘09 Mustang.
STEP 1: Start by removing the (2) screws found at the rear of the center console underneath the armrest.
STEP 2: Remove the trim plate which surrounds the Shifter Handle (Auto) or Shifter Boot (Manual).
Note: Manual transmission applications will require removing […]

[Read more →]

FRONT :
1.With vehicle on flat level ground, set the emergency brake and block the rear tires. Place floor jack under the lower control arm’s front cross member and raise vehicle. Place jack stands under frame rails, behind the front wheel wells, then lower the frame onto the stands. Remove the factory skid plate.
2. Remove the […]

[Read more →]

Prior to installation, carefully inspect the vehicle’s steering and drive train components. Be sure to check ball joints, tie rod ends, pan-rod bar, and control arm bushings. Everything must be tight and in good working condition.
• We recommend installation be done by a trained professional
• Read instructions carefully before attempting installation
• Secure and properly block […]

[Read more →]

If you are not familiar with the use of hand tools or not accustomed to working on motor vehicles, have a dealer or accessory shop install the X2000 Platinum Series EZ-Lift Lid. Carefully read all the instructions prior to attempting to fit the Lid. Before fitting the Lid, park the vehicle on level ground in […]

[Read more →]

STEP 1. Set emergency brake. Place gear selector away from dash. Open ashtray, depress push lever, and remove ashtray. Remove small trim insert located between flasher and defrost button by hooking small indent in the trim piece with hook tool and pulling out , set aside. Using Phillips screwdriver, locate and remove Phillips screw located […]

[Read more →]

Installation:
1. Establish the vehicle on flat ground. For easier installation lift rear of vehicle onto secure jack stands.
2. Remove rear wheels for ease of installation!
3. Remove the M6 screws that hold the emergency brake line (larger diameter cable) to the trailing arm. The smaller line is the ABS.
NOTE: on vehicles with ABS a metal cover […]

[Read more →]

All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.
TOOLS REQUIRED: Small flat screw driver, #2 Phillips screwdriver, hook tool, 5/64” drill bit, and drill, marking pen
STEP 1.
Begin by opening […]

[Read more →]

STEP 1. Set the emergency brake. Insert key into shift lock mechanism. With vehicle ignition off, put vehicle into gear. Remove ash tray by pressing on its face. It will pop open. Push down on lip located on top of ash tray. Ash tray will rotate out. Set aside. Next, remove the trim panel surrounding […]

[Read more →]