Automotive Manual, Car Parts and News

Read all instructions before starting any work.
1. Remove the O.E. inlet pipe/muffler/tail pipe welded assembly from the vehicle. Lubricate the rubber isolators with WD-40, or a similar product, to aid in removal of the metal rod hangers. Do NOT remove the exhaust pipe just ahead of the welded muffler assembly
2. Install DynoMax inlet pipe […]

[Read more →]

Read all instructions before starting any work.
1. It is suggested to lower or completely remove the spare tire from under the vehicle. This will help in the removal of the original equipment (OE) exhaust system and with the installation of the DynoMax exhaust kit.
2. Remove the existing exhaust system assembly from the vehicle. Lubricate the […]

[Read more →]

TO START:
1. Remove and inventory JBA exhaust
2. Disconnect negative battery cable and allow vehicle exhaust to cool.
3. With the vehicle raised and properly supported, using the 15mm socket and ratchet, loosen the clamp, at the rear of the muffler, that secures the tail pipe to the muffler.
4. Spray lubricant on the exhaust pipe behind the […]

[Read more →]

This B&M Short Throw Shifter has been designed to work on most 1991- 2001NissanSentra,1995-1998Nissan 200SX (US only), 1993-1997 Nissan Alitma,1990-1994Nissan Pulsar GTiR, 1991-1999 Nissan Sunny, 1995-2001 Nissan Maxima,and 1999-2000 Infiniti G20 models equipped with a manual transmission and includes a B&M Billet Aluminum Shift Knob. It has been engineered to greatly reduce shift throw and […]

[Read more →]

Before removing the original equipment oxygen sensor (hereinafter OE Sensor) from your vehicle, make note of the location of the connectors joining the oxygen sensor and vehicle wiring. The vehicle manufacturer has deemed this to be a suitable environment for a connection and it is recommended that the universal connector be installed close to the […]

[Read more →]

Installation Procedure
A. Check Kit Contents
1. Check kit for contents and damage.
B. Vehicle Preparation
1. Set vehicle parking brake.
2. Use a vehicle hoist or lift to raise vehicle to working height.
3. See owner’s manual for specified jacking or lift points if using a floor jack.
CAUTION: Use jack stands to support vehicle if a floor jack is used.

[Read more →]

The “Z-bar” clutch linkage that is used on Falcons and Comets might have been ok when these cars were born, but modern technology has given us many better alternatives. Early in the process of the ground up restoration of my 1963 Sprint hardtop, elimination of the “Z-bar” clutch linkage was one of the modern upgrades […]

[Read more →]

Faithful to the saying coined for Abarth cars in the 1960s (‘small but wicked’), the 500 Abarth promises to be a ‘small’ car with exceptional performance. It is powered by a 1.4 16v Turbo petrol engine which delivers a maximum of 135 bhp at 5000 rpm and peak torque of 206 Nm at 3000 rpm […]

[Read more →]

After much anticipation the Brera S is here! A collaboration with Prodrive to subtly enhance all that is good about the original Brera. Available in three exciting colours: Alfa Red, Carbonio Black and Touring Grey, all finished in Frau® black leather with red contrasting stitching.

[Read more →]