Automotive Manual, Car Parts and News

Installation recommendation: JBA recommends in most cases that the vehicle be taken to a reputable exhaust shop.
For 30-2535 and 50-2535 Only For Super cab/short bed trucks relocate the front muffler hanger to the hole on the side of the frame.
Start:
1. Remove and inventory new JBA exhaust system.
2. Disconnect negative battery cable and allow vehicle to […]

[Read more →]

TO START:
1. Remove and inventory JBA exhaust
2. Disconnect negative battery cable and allow vehicle exhaust to cool.
3. With the vehicle raised and properly supported, use a 15mm socket to remove the bolts that attach the exhaust system to the Catalytic converter.
4. Using a pry bar or a pair of channel lock pliers, remove hangers from […]

[Read more →]

Read all instructions before starting any work.
1. It is suggested to lower or completely remove the spare tire from under the vehicle. This will help in the removal of the original equipment (OE) exhaust system and with the installation of the DynoMax exhaust kit.
2. Remove the existing exhaust system assembly from the vehicle. Lubricate the […]

[Read more →]

Never work on a hot exhaust system. Serious injury in the form of burns can result If the vehicle has been in use and the exhaust system is hot, allow vehicle to cool for at least 1 hour. Always wear eye protection when working under any vehicle. Note: It is our recommendation that you use […]

[Read more →]

Removal of original system
1.) start under the hood. locate the turbo. remove the v-clamp from the turbo outlet. loosen the bolt enough to unlatch the t-bolt, then pry the clamp away from the flange at three spots using a flathead screwdriver.
2.) from underneath your vehicle, cut the stock system in two places. first, cut the […]

[Read more →]

Removal of Stock System:
1. Separate the stock exhaust system at the slip joint by the muffler. Remove the rear exhaust from rubber hangers and remove the system from under the truck.
2. Using a 15mm socket or wrench, remove the two (2) bolts at the turbo flange and remove the stock down pipe.
Installing Your Front Section […]

[Read more →]

TO START:
1. Remove and inventory JBA exhaust.
2. Disconnect negative battery cable and allow vehicle exhaust to cool.
3. With the vehicle raised and properly supported, spray lubricant on all rubber isolators. Using the pry bar, remove rubber isolators from muffler hangers.
4. Remove the factory exhaust clamp located directly behind the catalytic converter.
5. Remove the tail pipe […]

[Read more →]

This Borla Performance Cat-Back™ Exhaust System (Part number 140105) has been designed for 2002-2005 Nissan Altima equipped with a 3.5L V-6 engine and automatic or manual transmissions. Borla Performance Industries recommends that an exhaust shop or professional after market parts installer, who has all the necessary equipment, tools and experienced personnel needed for proper installation, […]

[Read more →]

This B&M Short Throw Shifter has been designed to work on most 1991- 2001NissanSentra,1995-1998Nissan 200SX (US only), 1993-1997 Nissan Alitma,1990-1994Nissan Pulsar GTiR, 1991-1999 Nissan Sunny, 1995-2001 Nissan Maxima,and 1999-2000 Infiniti G20 models equipped with a manual transmission and includes a B&M Billet Aluminum Shift Knob. It has been engineered to greatly reduce shift throw and […]

[Read more →]

When installing this exhaust system make sure to use proper safety precautions. Use jack stands when under the truck, set parking brake, block tires and use safety glasses and gloves.
Lay out the exhaust on the floor so it looks like the drawing and compare parts with manual. To remove the stock exhaust remove it from […]

[Read more →]