Automotive Manual, Car Parts and News

The recommended push beam height for this undercarriage assembly is 12-1/2″ from the center of the push beam to level ground. DO NOT exceed 14-1/2″ in height for this undercarriage.
WARNING: Always perform vehicle undercarriage installations with the keys removed from the vehicle’s ignition. Properly tag the ignition switch to alert others work is being performed […]

[Read more →]

Read all instructions before starting any work.
1. Remove the O.E. inlet pipe/muffler/tail pipe welded assembly from the vehicle. Lubricate the rubber isolators with WD-40, or a similar product, to aid in removal of the metal rod hangers. Do NOT remove the exhaust pipe just ahead of the welded muffler assembly
2. Install DynoMax inlet pipe […]

[Read more →]

TO START:
1. Remove and inventory JBA exhaust
2. Disconnect negative battery cable and allow vehicle exhaust to cool.
3. With the vehicle raised and properly supported, use a 15mm socket to remove the bolts that attach the exhaust system to the Catalytic converter.
4. Using a pry bar or a pair of channel lock pliers, remove hangers from […]

[Read more →]

Step 1: Position truck on a flat surface and lift front wheels off of ground using jack stands or a (2) two post lift if available, and remove the driver’s side front wheel. Next loosen and remove the Upper ball joint nut, Tie rod nut and Sway bar nut on the same side of the […]

[Read more →]

The mounting procedure outlined below covers 1992 – 1996 FORD F150 trucks. You will need to refer to the illustrations and familiarize yourself with each of the undercarriage components and their relative position to each other. Then proceed as follows:
1. Remove the front bumper. If the truck is equipped with a front stabilizer bar, remove […]

[Read more →]

Let’s start with the rear door:
First, unscrew the two Philips head machine screws that hold the flip-out window latch to the door frame. Swing the latch toward the window to get it out of the way. Then the upper trim panel pulls straight away from the door. You may want to slide a thin screwdriver […]

[Read more →]

For easier assembly and installation, vehicle and all snowplow components should be on a smooth, level, hard surface, such as concrete.
1. Remove license plate bracket and retain for vehicle owner. Remove bumper from bumper brackets. Retain fasteners.
2. Remove bumper brackets from frame. Retain fasteners.
Diesel applications: On these applications, you must first remove the top two […]

[Read more →]

The mounting procedure outlined below covers 1973 - 1993 Dodge W250 & W350 trucks. You will need to refer to the illustrations and familiarize yourself with each of the undercarriage components and their relative position to each other. Then proceed as follows:
1. Remove the Front Bumper and Front Bumper Mounting Brackets from the Frame Horns. […]

[Read more →]

1. Remove the bumper and adjustable bumper mount plates from the truck frame rail. NOTE: The fascia will need to be permanently removed or notched for reinstallation. Discard mount plate hardware.
2. Install the support arms (Ref 8 & 9) to the truck frame rail. The passenger side will install behind the front stabilizer bar and […]

[Read more →]

PRE-INSTALLATION NOTES
1. Special literature required: OE Service Manual for model/year of vehicle. Refer to manual for proper disassembly/reassembly procedures of OE and related components.
2. Adhere to recommendations when replacement fasteners, retainers and keepers are called out in the OE manual.
3. Larger rim and tire combinations may increase leverage on suspension, steering, and related components. When […]

[Read more →]