Automotive Manual, Car Parts and News

Step 1: Prior to lifting the vehicle it is recommended that you measure the stock height so that you have a base line measurement. Measure from the bottom of the wheel to the lip of the fender, as in Insert A. Position truck on a flat surface and lift vehicle by the frame so that […]

[Read more →]

Installation Mechanical
Step 1 Tank Install
Mount tank as high in engine compartment as possible using #8×1―” sheet metal screws and washers provided.
Optional: If windshield washer reservoir is utilized, mount quick-connect bulkhead in the bottom using “Goop” sealant or similar methanol resistant adhesive/sealant.
The following procedure will allow the use of a nut on both sides of bulkhead […]

[Read more →]

Installation by a trained mechanic is recommended
Step 1: Position vehicle on a flat surface and lift vehicle by the frame so that the front wheels are off the ground. Use a floor jack and jack stands or a (2) two post lift if available. Next, locate the torsion key at the rear of the torsion […]

[Read more →]

Step 1: (A) Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground using a floor jack and jack stands or a (2) two post lift if available. Next locate the torsion key at the rear of the torsion bar under the cab of […]

[Read more →]

Removing the stock air inlet system
a) Before removing any of the O.E. components, label each individual part so that no components become mixed up during the installation process.
b) Stock air system
c) Unplug the Inlet Air Temperature Sensor (IAT) from the stock resonator box
d) Remove the breather hose from the plastic tee (Vehicles equiped with plastic […]

[Read more →]

Most 17” wheels will clear the outer diameter of the caliper for a 328mm or 332mm rotor kit. For a 355mm kit, a minimum 18” wheel is typically required, and for a 380mm rotor kit, a minimum 19” wheel is needed. The more critical clearance, however, is the gap between the spokes of the wheel […]

[Read more →]

1. Cold air shown. Kit can also be short ram.
2. Complete Stock intake. Please disconnect battery terminals before installation.
3. Disconnect MAF sensor harness. Unclip upper half of air box. Loosen clamps using 10mm socket or wrench.
4. Remove crank case line.
5. Remove stock intake tube and upper air box.
6. With 10mm socket or wrench loosen bolt […]

[Read more →]

Installation of the side strakes should taoe approximately 30 minutes per side to complete following these simple instructions. Allow yourself plenty of time. There is no need to rush and potentially make mistakes that could lead to additional work or worse, damage to your new strakes. Please read through these instructions entirely before beginning the […]

[Read more →]

1) Disconnect the battery.
2) Remove fender:
Remove all Phillip’s screws or fasteners from the wheel well. Usually you will have to remove bolts to loosen the bumper Remove all bolts from the bottom of the fender by the door. Remove bolts from the top of the fender. Usually you will have to remove (1) bolt holding […]

[Read more →]

Step 1 - Unpack QuickLIFT kit and verify contents.
Remove all items from the packing tube. You should have the following before beginning:
* (2) Gas springs (RT-QL-200-7A) - Be sure to cycle them a few times before installing.
* (8) 3/16″ Multi-grip Rivets - #1 Short MG.
* (2) Large steel brackets - fender
* (2) Small steel brackets […]

[Read more →]