Automotive Manual, Car Parts and News

GENERAL NOTES:
1. THIS SYSTEM SHOULD ONLY BE INSTALLED BY A PROFESSIONAL MECHANIC.
2. Compare all contents of the boxes to the parts list before starting to insure all components are included.
3. Prior to installing the suspension system, inspect the vehicle’s suspension components, alignment, and frame for damage, corrosion, or cracks. Correct any worn or damaged parts […]

[Read more →]

1. Before beginning the installation, please read the instructions thoroughly and verify that the hardware kit is complete. If any of the pieces listed above are missing, call you distributor immediately to obtain the necessary items.
2. Identify your product´s components. Tips: The front of the side bar has the step pad farther from the edge […]

[Read more →]

1) Front brackets are identical and are simply turned 180 degrees out so face of bracket is facing outside of truck.
2) Bars can be mounted either side and are identical.
3) Body mount torque is 65 ft.-lbs.
4) Holes in rocker panel are usually covered with black or grey tape from manufacturer

[Read more →]

Read instructions before assembling. Fasteners should be finger tight until instructed to tighten according to the torque chart. Use standard methods and practices when attaching snowplow including proper personal protective safety equipment.
MOUNT INSTALLATION
1. If the vehicle is equipped with a stamped-steel splash guard and/or tow hooks, remove them. Retain the splash guard, tow hooks, and […]

[Read more →]

FRONT OF FRONTIER
1. Park vehicle on level concrete surface.
2. Center and lock the steering wheel.
3. Block the rear wheels of the vehicle to prevent vehicle from moving in either direction.
4. Jack up the vehicle from the lift point in Figure A.
5. Support the vehicle with jack stands from the points in Figure A.
6. Remove the […]

[Read more →]

Complete Stock passenger side intake. Please disconnect battery terminals before installation.
With 10mm socket or wrench, loosen the 2 bolts holding in lower engine cover and remove.
Disconnect MAF sensor harness. With 10mm socket or wrench loosen bolt holding in air box.
Loosen clamps on intake using 5/16” nut driver.
With pliers pull back crank case line from intake.
Remove […]

[Read more →]

For Nissanо and Tohatsuо 40C, 40D, and 50D models: (Omit included #N513 and #NT6070 SPACERS. They are for 50C to 70B models.)
1) Make sure your OEM thrust washer is in place. Clean and grease the splines of the prop shaft. (Any marine grade grease is acceptable.)
2) Slide HUB ASSEMBLY into PROPELLER HOUSING from the front.
3) […]

[Read more →]

1. Cold air shown. Kit can also be short ram.
2. Complete Stock intake. Please disconnect battery terminals before installation.
3. Disconnect MAF sensor harness. Unclip upper half of air box. Loosen clamps using 10mm socket or wrench.
4. Remove crank case line.
5. Remove stock intake tube and upper air box.
6. With 10mm socket or wrench loosen bolt […]

[Read more →]

1. Remove one factory sheet metal screw on the front fender and the three front plastic clips from underneath the plastic molded side skirt (Figure 1). Once these are removed, gently pull on the plastic side skirt to locate the factory hole on the side panel (Figure 2).
2. Mark the location of the factory hole […]

[Read more →]

Removing the stock air inlet system
a) Before removing any of the O.E. components, label each individual part so that no components become mixed up during the installation process. There is a Ventilation Hose, an Intake Air Temp. Sensor, Purge Solenoid Valve, and a Mass Air Flow Sensor (MAF). Refer to the following diagrams for the […]

[Read more →]