1. Make sure all tires are inflated to the vehicle’s recommended inflation pressures (found in the owner’s manual on the door placard).
2. Turn the ignition switch to OFF then press and release the brake pedal.
3. Turn the ignition switch from OFF to RUN (engine OFF) 3 times, ending in the RUN position. Do this within [...]
Ford/Mercury/Lincoln Band-Mounted Sensor Re-Learn Instructions
February 27th, 2010 · No Comments
Mercury ABS G-Force Sensor Modules Removal Instructions
October 29th, 2009 · No Comments
Only the ABS G-Force sensor modules should be removed and collected in the Switch Out containers. ABS wheel speed sensors in wheel units do not contain mercury and should not be removed. ABS G-Force sensor module removal instructions for specific vehicle types are listed below.
ABS G-Force sensor module removal procedures for specific vehicle types are [...]
On-Board Programming Instructions
October 21st, 2009 · No Comments
GM Pass-Key III (Easily identified by a ‘PK3’ stamped on the blade)
ORIGINATE A NEW KEY:
1. Insert new transponder key and turn ignition to ‘ON’ position. The dashboard security light will turn on and stay on for 10 minutes.
2. Once the security light goes out, you have one minute to to begin Step 3. Turn ignition [...]
Pk3 Key Programming, on board key programming ford 2009, gm onboard key programming, how to disable the security feature on a 2000 ford windstar, on board programming
