Automotive Manual, Car Parts and News

The mounting procedure outlined below covers 1992 – 1996 FORD F150 trucks. You will need to refer to the illustrations and familiarize yourself with each of the undercarriage components and their relative position to each other. Then proceed as follows:
1. Remove the front bumper. If the truck is equipped with a front stabilizer bar, remove […]

[Read more →]

Tools required: - Vehicle ramp or Jack and axle stands, T25 Torx driver, T30 Torx driver, 8mm spanner, 10mm socket, ratchet and extension bar, Pozzidrive screwdriver, Flat blade screwdriver, Trim removal type tool, Protective clothing, footwear and eyewear are also recommended.
1. Raise the vehicle on a ramp or place on axle stands. Open bonnet. Remove […]

[Read more →]

GENERAL NOTES:
1. THIS SYSTEM SHOULD ONLY BE INSTALLED BY A PROFESSIONAL MECHANIC.
2. Compare all contents of the boxes to the parts list before starting to insure all components are included.
3. Prior to installing the suspension system, inspect the vehicle’s suspension components, alignment, and frame for damage, corrosion, or cracks. Correct any worn or damaged parts […]

[Read more →]

As you read through this procedure, note that each part referenced has the same callout number throughout. Also, the part number in the text matches the corre- sponding part number in the art. Kit parts are prefaced by the word kit in italics.
NOTE
You will find it easier to keep track of hardware if immediately after […]

[Read more →]

All hardware should be tightened only enough to ensure safety during assembly. Fully tighten all hardware after entire assembly is completed.
1. Remove the plastic air dam from the bottom of the front bumper. The air dam cannot be reinstalled when this mount kit is on the truck and should be returned to the vehicle owner […]

[Read more →]

The mounting procedure outlined below covers 1973 - 1993 Dodge W250 & W350 trucks. You will need to refer to the illustrations and familiarize yourself with each of the undercarriage components and their relative position to each other. Then proceed as follows:
1. Remove the Front Bumper and Front Bumper Mounting Brackets from the Frame Horns. […]

[Read more →]

Get ready to install the kit.
1. Remove the shift transfer case shift linkage.
a. If present on your vehicle, remove four bolts and skid plate from the frame under the transmission and transfer case.
b. Remove two rubber bushings and transfer case shift linkage from shift lever and transfer case.
2. Remove the front bumper.
a. Remove nine panel […]

[Read more →]

Read instructions before assembling. Fasteners should be finger tight until instructed to tighten according to the torque chart. Use standard methods and practices when attaching snowplow including proper personal protective safety equipment.
MOUNT INSTALLATION
1. If the vehicle is equipped with a stamped-steel splash guard and/or tow hooks, remove them. Retain the splash guard, tow hooks, and […]

[Read more →]

Disconnect the negative battery terminal before starting this installation.
1. Remove the air intake duct, the air intake box and the air vacuum lines connected to the air box. Unbolt the air mass sensor from the air box and set aside at this point. This installation also requires removal of the front bumper and the air […]

[Read more →]

Thank you for purchasing the Harman Motive Intake System for the Nissan R35 GTR. We know you’ll appreciate the quality and performance of this Harman Motive product. These instructions are intended as a guide to properly install your product. Please take care and take your time. Should you have any questions or comments, please don’t […]

[Read more →]