Automotive Manual, Car Parts and News

FRONT OF VEHICLE – DISASSEMBLY AND ASSEMBLY
1. Park vehicle on level, hard (concrete) surface.
2. Block the rear wheels of the vehicle to prevent vehicle from moving in either direction and set parking brake.
3. Remove the track bar bolt 30 mm (save for later use) on the driver side of the frame mount (Fig.1), and the […]

[Read more →]

1. Remove tailgate by disconnecting the tether cable and lifting the tailgate out at approximately a 45º angle. Reference the truck’s Owner’s manual.
2. Carefully remove the OEM tailgate pivot cups from the tailgate taking note of which side they belong on.
NOTE: On F-150 (FD80002) make sure the OEM left side pivot cup remains on the […]

[Read more →]

Get ready to install coil spring leveling kit.
1. Lift front wheel assemblies.
a. If so equipped, remove two caps (4) from front wheels (5)
b. Loosen eight lug nuts (6) each from two front wheels (5).
c. Using a hydraulic jack, slowly lift front of vehicle so that two front tires (7) are three to five inches off […]

[Read more →]

1) Front brackets are identical and are simply turned 180 degrees out so face of bracket is facing outside of truck.
2) Bars can be mounted either side and are identical.
3) Body mount torque is 65 ft.-lbs.
4) Holes in rocker panel are usually covered with black or grey tape from manufacturer

[Read more →]

1. Remove tailgate by disconnecting the tether cable and lifting the tailgate out at approximately a 45º angle. (Reference the truck’s Owner’s manual)
2. Carefully remove the OEM tailgate pivot cups from the tailgate taking note of which side they belong on.
3. Remove tether bolt. A special wrench may be required.
4. Remove latch pin bolt. A […]

[Read more →]

Power Step - Installation Instructions
1. Drill Holes for Arms
Locate the Drill Template in the parts kit. Place it along the sill under the vehicle. Slide the upper front hole in the template over the stud in the sill and install an 8mm Nut over the stud. Then install a Medium Socket Head Bolt in the […]

[Read more →]

1) Remove front engine mount upper bolt with 14mm socket. The front engine mount is located on the timing cover side of the engine also known as the front of the engine.
2) Install the small torque link bracket as shown in picture. Use supplied M10 bolt and tighten to finger tight. A 13mm wrench or […]

[Read more →]

Please read the instructions completely prior to installation.
1. Raise front of vehicle and support with jack stands. (Refer to the owner’s manual for proper jack points.) Be sure to block the rear wheels to prevent the vehicle from rolling.
2. Remove wheels.
3. Remove the mounting bolts for the stock caliper, but do not disconnect the brake […]

[Read more →]

The JG Edelbrock short shifter uses a stock style distance pin riding on two DU self-lubricated bearings. ACCESSORIES & INSTALLATION ITEMS: Our billet shifter knob PN 4709 is the ultimate choice to complement your new JG Edelbrock shifter. The threads on this shifter (M10×1.5) are compatible with the stock or any stock replacement shifter knob.

[Read more →]