Automotive Manual, Car Parts and News

Read all instructions before starting any work.
1. Remove the O.E. inlet pipe/muffler/tail pipe welded assembly from the vehicle. Lubricate the rubber isolators with WD-40, or a similar product, to aid in removal of the metal rod hangers. Do NOT remove the exhaust pipe just ahead of the welded muffler assembly
2. Install DynoMax inlet pipe […]

[Read more →]

TO START:
1. Remove and inventory JBA exhaust
2. Disconnect negative battery cable and allow vehicle exhaust to cool.
3. With the vehicle raised and properly supported, use a 15mm socket to remove the bolts that attach the exhaust system to the Catalytic converter.
4. Using a pry bar or a pair of channel lock pliers, remove hangers from […]

[Read more →]

Never work on a hot exhaust system. Serious injury in the form of burns can result If the vehicle has been in use and the exhaust system is hot, allow vehicle to cool for at least 1 hour. Always wear eye protection when working under any vehicle. Note: It is our recommendation that you use […]

[Read more →]

Removal of original system
1.) start under the hood. locate the turbo. remove the v-clamp from the turbo outlet. loosen the bolt enough to unlatch the t-bolt, then pry the clamp away from the flange at three spots using a flathead screwdriver.
2.) from underneath your vehicle, cut the stock system in two places. first, cut the […]

[Read more →]

Removal of Stock System:
1. Separate the stock exhaust system at the slip joint by the muffler. Remove the rear exhaust from rubber hangers and remove the system from under the truck.
2. Using a 15mm socket or wrench, remove the two (2) bolts at the turbo flange and remove the stock down pipe.
Installing Your Front Section […]

[Read more →]

TO START:
1. Remove and inventory JBA exhaust.
2. Disconnect negative battery cable and allow vehicle exhaust to cool.
3. With the vehicle raised and properly supported, spray lubricant on all rubber isolators. Using the pry bar, remove rubber isolators from muffler hangers.
4. Remove the factory exhaust clamp located directly behind the catalytic converter.
5. Remove the tail pipe […]

[Read more →]

TO START:
1. Remove and inventory JBA exhaust
2. Disconnect negative battery cable and allow vehicle exhaust to cool.
3. With the vehicle raised and properly supported, using the 15mm socket and ratchet, loosen the clamp, at the rear of the muffler, that secures the tail pipe to the muffler.
4. Spray lubricant on the exhaust pipe behind the […]

[Read more →]

By installing your Borla Performance Exhaust System, you indicate that you have read this document and you agree with the terms stated below. It is the responsibility of the purchaser to follow all installation instruction guidelines and safety procedures supplied with your Borla Performance Exhaust System
Borla Performance Industries assumes no responsibility for damages occurring from […]

[Read more →]

This Borla Performance Cat-Back™ Exhaust System (Part number 140105) has been designed for 2002-2005 Nissan Altima equipped with a 3.5L V-6 engine and automatic or manual transmissions. Borla Performance Industries recommends that an exhaust shop or professional after market parts installer, who has all the necessary equipment, tools and experienced personnel needed for proper installation, […]

[Read more →]

Read all instructions before starting any work.
1. Remove the O.E. exhaust from the flanged connections behind the catalytic converters. Lubricate the rubber isolators with WD-40, or a similar product, to aid in removal of the metal rod hangers.
2. Install DynoMax RH y-pipe 52312 and LH cross-over pipe 52313. Insert the metal rod hanger on 52312 […]

[Read more →]