Automotive Manual, Car Parts and News

This air bag system was designed around a stock exhaust configuration. Some aftermarket exhaust systems will require modifications to the tail pipe!
• We recommend installation be done by a trained professional.
• Read instructions carefully before attempting installation.
• Secure and properly block vehicle prior to installation.
NOTE: Installation will be done with rear axle at full droop […]

[Read more →]

BEFORE PAINTING – FIT BUMPER COVER AS FOLLOWS:
1. Remove the factory Air Dam by removing the five 10 mm hex bolts; discard the bolts and Air Dam.
2. Using the T30 Torx Bit and remove the two torx head bolts at each end of the factory painted upper bumper cover; save these bolts.
3. Using a stanley […]

[Read more →]

We recommend fully reading the installation instructions before beginning.
1. Begin by installing the pushrod adjuster into the rocker arm. The cupped side faces down and is where the pushrod makes contact. Screw the adjuster in until only the first thread is shown on the bottom side of the rocker arm.
2. Install the pushrod adjuster jam […]

[Read more →]

The following instruction should be followed to install the king pin Trailer Plate.
FOR KING PIN BOXES WITH A FLANGE:
1. Place the Capture Plate {J2} over the king pin, with the guide wedge towards the rear of the trailer (wedge facing down). Align the Capture Plate {J2} square with the king pin box and clamp in […]

[Read more →]

This inlet pipe kit requires the removal and reinstallation of emissions related components. If you are not familiar with the installation and/or the operation of these components then please refer this installation to a qualified professional.
Installing the Short Ram Air Intake System
a) When installing the AEM Air Intake System, DO NOT completely tighten the hose […]

[Read more →]

Installing the Short Ram Air Intake System
a) When installing the Short Ram Air Intake System, DO NOT completely tighten the hose clamps or mounting tab hardware until instructed to do so later in these instructions.
b) Check to see that the inside of the AEM inlet pipe and air filter are clean and free from any […]

[Read more →]

PROCEDURE
1. Begin installation by working on driver side of the vehicle starting at the front of the inner rocker panel.
2. Located on the inside as well as the bottom inner of the rocker panel you will see one thread hole and one thread stud for each mounting bracket refer to diagram 1. (Note all brackets […]

[Read more →]

Three heads can be used for the twin cam conversion.
• RB26DETT Head
• RB25DE (R32) Head
• RB25DE/T (R33) VCT Head
All three heads cc up around the 62-64cc mark.
However, please be sure to double check, there have been cases where people have bought heads that for some reason are way off. Possibly aftermarket.

[Read more →]

The Victor small-block Ford cylinder heads are designed for ultra high-performance 302 through 351 c.i.d. and large displacement Ford Windsor V8s. These heads feature .52″ raised exhaust ports and .375″ raised high flow intake ports. A .375″ extended intake port flange is compatible with all Victor-series 302 and 351-based manifolds using the end seal spacers […]

[Read more →]