Automotive Manual, Car Parts and News

Installation recommendation: JBA recommends in most cases that the vehicle be taken to a reputable exhaust shop.
For 30-2535 and 50-2535 Only For Super cab/short bed trucks relocate the front muffler hanger to the hole on the side of the frame.
Start:
1. Remove and inventory new JBA exhaust system.
2. Disconnect negative battery cable and allow vehicle to […]

[Read more →]

This air bag system was designed around a stock exhaust configuration. Some aftermarket exhaust systems will require modifications to the tail pipe!
• We recommend installation be done by a trained professional.
• Read instructions carefully before attempting installation.
• Secure and properly block vehicle prior to installation.
NOTE: Installation will be done with rear axle at full droop […]

[Read more →]

1. Turn off the ignition and disconnect the negative battery cable. NOTE: Disconnecting the negative battery cable erases pre-programmed electronic memories. Write down all memory settings before disconnecting the negative battery cable. Some radios will require an anti-theft coded to be entered after the battery is reconnected. The anti-theft code is typically supplied with your […]

[Read more →]

To Start the installation:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Unlock the red locking tab on the air temperature sensor electrical connection, then depress the locking lever and pull apart the temperature sensor electrical connection
3. Loosen the hose clamp that secures the intake tube to the throttle body and pull […]

[Read more →]

Removing the stock air inlet system
a) Before removing any of the O.E. components, label each individual part so that no components become mixed up during the installation process.
b) Stock air system
c) Unplug the Inlet Air Temperature Sensor (IAT) from the stock resonator box
d) Remove the breather hose from the plastic tee (Vehicles equiped with plastic […]

[Read more →]

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the air temp. sensor electrical connection.
3. Loosen the hose clamps at the turbo inlet and the airbox outlet as shown.
4. Remove the intake tube from the vehicle as shown.
5. Loosen and remove the 10mm nut that retains the airbox to the […]

[Read more →]

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the mass air sensor electrical connection and unhook the harness from the air box.
3. Remove the two bolts shown, which secure the engine cover.
4. Lift firmly on the engine cover to dislodge it from the mounting grommets, and then remove the […]

[Read more →]

Track Dog Racing Exhaust Heat Shield, which is designed to help maintain lower temperatures in the engine compartment by isolating elevated header temperatures. The TDR Heat Shield will install on all model years of the Mazda Miata. Both factory exhaust manifolds and aftermarket headers will see the benefits of reduced heat transfer in the engine […]

[Read more →]

NOTE: If you have a lighted gearshift knob, do this first !!!
-At the base of the gear lever is a shift boot surrounding the lower shaft.
-Remove the shift boot by detaching the shift boot base from the console area, it is snapped in at the four sides.
-Locate the lighted knob wire that comes from the […]

[Read more →]