Automotive Manual, Car Parts and News

Instructions for Bravada, Rainier and Blazer start here. See below for other instructions
STEP #1: Partially pull off the bezel that surrounds the vents, radio, climate control, and power outlets (Bravada only). Start from the top of the bezel with the hook tool, and working your way to the bottom releasing a total of (6) clips. [...]

[Read more →]

All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.
Pro.Fit logo and part number will be right side up and readable when installed.
TOOLS REQUIRED: #1 Phillips screwdriver, hook tool, marking [...]

[Read more →]

TOOLS REQUIRED: #2 Phillips screwdriver, hook tool, 9/32” & 5/16” sockets & driver, telescopic magnet, 5/64” drill bit and drill, protective cloth, marking pen.
PARTS INCLUDED: Pro.Fit VSMTM , instructions, two (2) # 10x 5/8” screws.
LOCATION: To the right of the radio
STEP 1. Begin by removing the simulated wood grain bezel that surrounds the ashtray. Insert [...]

[Read more →]

PLEASE READ COMPLETE INSTRUCTIONS BEFORE INSTALLING THIS Pro.Fit MOUNT. All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break
STEP 1.
Begin by removing trim bezel that surrounds climate control. Insert hook [...]

[Read more →]

STEP 1. Set emergency brake. Place gear selector away from dash. Open ashtray, depress push lever, and remove ashtray. Remove small trim insert located between flasher and defrost button by hooking small indent in the trim piece with hook tool and pulling out , set aside. Using Phillips screwdriver, locate and remove Phillips screw located [...]

[Read more →]

STEP 1. Begin by removing the air vent assembly above the climate control module. There are three (3) clips on the top and four (4) clips on the bottom of the vent. (See photo # 3.) Slide your hook tool between the vent assembly and dash. Push the clip towards the vent to release it, [...]

[Read more →]

STEP 1. Begin by inserting hook tool at very back of trim panel surrounding gear shift selector. Release two (2) clips at the rear and continue towards front of panel to release two (2) more clips. CAUTION! These parts are plastic and this panel comes out extremely hard.
STEP 2. Remove ashtray by removing screw on [...]

[Read more →]

All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.
TOOLS REQUIRED: Small flat screw driver, #2 Phillips screwdriver, hook tool, 5/64” drill bit, and drill, marking pen
STEP 1.
Begin by opening [...]

[Read more →]