Installation:
1. This Hi-Flow system replaces the Nissan Maxima OEM air box. Briefly, the OEM air box is held in place with three bolts (lower housing), support bracket bolt (behind the mass sensor), and a hose clamp (mass sensor). The air box itself consists of two halves the upper housing which attaches to the mass sensor […]
1995-96 Nissan Maxima Stillen Hi-Flow Intake Installation Instructions
November 10th, 2009 · No Comments
2006-2008 Mazda MX-5 CAS Cold Air Intake System Installation Instructions
October 23rd, 2009 · No Comments
Removing the stock air inlet system
a) Before removing any of the O.E. components, label each individual part so that no components become mixed up during the installation process.
b) Unclip the hard plastic breather hose from the breather nipple by squeezing the blue retaining clip. Slide the purge solenoid valve (PSV) toward the back of the […]
Mitsubishi 3000GT VR4 and Dodge Stealth RT/TT PPE Engineering Front Mount Intercooler Pipes
September 21st, 2009 · No Comments
Pre-Installation:
1. Remove all stock intercooler pipes and intercoolers (Refer to Factory Service Manual for removal instructions)
2. Install Front Mount Intercooler. (Refer to FMIC installation section)
3. Unbolt Oil Cooler and move forward at least one inch.
a. Remove upper bracket
b. Bolt lower hole to existing hole where factory intercooler was.
c. Mark hole for upper side bracket hole
d. […]
Search engine terms: MAXIMA 95 CHECK ENGINE RESET, nissan maxima air intake duct, how to reset engine light on a 96 maxima, check engine nissan maxima 1995, 95 MAXIMA CEL Reset, NISSAN MAXIMA 1995 AIR INTAKE HOUSING, 2003 altima mass flow sensor installation, nissan maxima 1995 pulley installation,
