Automotive Manual, Car Parts and News

Read all instructions before starting any work.
1. Remove the O.E. inlet pipe/muffler/tail pipe welded assembly from the vehicle. Lubricate the rubber isolators with WD-40, or a similar product, to aid in removal of the metal rod hangers. Do NOT remove the exhaust pipe just ahead of the welded muffler assembly
2. Install DynoMax inlet pipe […]

[Read more →]

On this particular model vehicle, there is not splashguard underneath the vehicle. This means that the air filter is exposed to the outside elements. Extreme care must be taken while driving the vehicle in the rain. If you have to traverse any deep water, do so with extreme caution. If rains are intense, it may […]

[Read more →]

Removing the stock air inlet system:
a) Loosen the five screws securing the stock air box lid. Remove the air box lid from the vehicle.
b) Remove the Inlet Air Temperature (IAT) sensor. The metal band will need to be pried off with a flat-head screwdriver. Use care to avoid damaging the IAT sensor.
c) Remove the air […]

[Read more →]

This inlet pipe kit requires the removal and reinstallation of emissions related components. If you are not familiar with the installation and/or the operation of these components then please refer this installation to a qualified professional.
Installing the Short Ram Air Intake System
a) When installing the AEM Air Intake System, DO NOT completely tighten the hose […]

[Read more →]

Installing the Short Ram Air Intake System
a) When installing the Short Ram Air Intake System, DO NOT completely tighten the hose clamps or mounting tab hardware until instructed to do so later in these instructions.
b) Check to see that the inside of the AEM inlet pipe and air filter are clean and free from any […]

[Read more →]

This inlet pipe kit may require the removal and reinstallation of emissions related components. If you are not familiar with the installation and/or the operation of these components then please refer this installation to a qualified professional.
Removing the stock air inlet system
a) Remove the bolts and nut holding the strut tower bar in place. Unclip […]

[Read more →]

Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Disconnect all negative battery terminals.
e. Jack up front of the vehicle and place on properly rated jack stands.
f. Remove driver’s side fender liner.
g. Do not discard stock components after […]

[Read more →]

Removing the stock air inlet system
a) Stock intake system.
b) Free differential breather hose from inlet tube, if equipped. Use a supplied zip tie to secure the hose to the brake booster tube.
c) Pull the crankcase breather hose from the valve cover.
d) Loosen the two hose clamps on the ends of the inlet pipe. Remove the […]

[Read more →]

Read and understand these instructions BEFORE attempting to install this product. Failure to follow installation instructions and not using the provided hardware may damage the intake tube, throttle body and engine.
Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool […]

[Read more →]

Removing the stock air inlet system
a) Before removing any of the O.E. components, label each individual part so that no components become mixed up during the installation process. There is a Ventilation Hose, an Intake Air Temp. Sensor, Purge Solenoid Valve, and a Mass Air Flow Sensor (MAF). Refer to the following diagrams for the […]

[Read more →]