Automotive Manual, Car Parts and News

RSS Feed

Free PDF Download, Car Parts and Automotive News

2011+ Nissan Juke GTM Juke Intercooler Piping Kit Installation Manual

September 26th, 2011 · No Comments

With the engine cool, remove the engine cover and the components that are highlighted red in the picture below. Remove the mounting rubber grommets from the piping and save for re-installation (highlighted green).

[Read more →]


Dodge Sleevoil Auxiliary Seal and End Cap Kits Installation Manual

December 8th, 2010 · No Comments

Consult construction drawing or specifications to determine which type of auxiliary seal or end closure is to be used for the installation. Neither these instructions nor the instructions packed with the pillow block specify which type of auxiliary seal is to be used.
Standard Auxiliary Seal Kit
1. Remove parts from box, clean parts and inspect for [...]

[Read more →]


Dodge RAM 47RE Transmission BD Valve Body Installation Manual

December 2nd, 2010 · No Comments

Installing the BD Valve Body 2000-04 Dodge Ram
All Diesel Rams should be tested prior to engine or transmission performance tuning. Check transmission oil level prior to all work. Pressure testing will produce test results that can help to determine the ability of the transmission to prevent the clutch surfaces from slipping. Slippage will result in [...]

[Read more →]


MSD Digital DIS-2 Dual Channel Ignition Installation Instructions

December 1st, 2010 · No Comments

The MSD Digital DIS-2 Dual Channel Ignition can be used on 4-cylinder engines equipped with two dual output coils. The MSD Digital DIS-4 Multi Channel Ignition can be used on 4, 6 or 8-cylinder engines equipped with up to four dual output coils. The MSD Digital DIS Ignition will accept trigger inputs from electronic DIS [...]

[Read more →]


2004-05 Dodge Magnum Bumper Grille Installation

December 1st, 2010 · No Comments

Installation procedures:
Place U-clips on all (4) brackets as shown above. Next using the #8 x 1” Phil Pan Head Screw, put it thru the front of the billet grille as shown with the nylon spacers being on the inside of the billet grille. It may be necessary to use a small piece of masking tape [...]

[Read more →]


1995 Mazda MX-6 Brake System Remove & Installation

December 1st, 2010 · No Comments

FRONT DISC BRAKE PADS
Removal & Installation
1. Raise and support front of vehicle. Remove front wheel assemblies. Remove lower lock pin/guide bolt. See Fig. 2 . Pivot caliper upward and support using rope.
2. Remove pads, shims, guide plates or pad guides and “V” springs (if equipped). Replace pad if lining thickness is less than specified. See [...]

[Read more →]


Passat B6 / 3C Inner Tail Light Install aka Skyline lights

November 26th, 2010 · No Comments

Wiring for the inner taillight: The below instructions assume you are not using the factory single rear fog light and have 2 reverse lights. If you have a World car or right-hand drive, some of the settings are different and you may not need to make any VAGCOM (VCDS) changes.
Option 1: Use as additional tail [...]

[Read more →]


Mazda Speed 3 King Clamp Install Manual

November 26th, 2010 · No Comments

(Not liable for errors in installation. If unsure at any time consult a Professional) Start by taking the battery lid as well as the ECU cover off and locate the wires according to this diagram. The connector your want to look at is the one on the left and there are 4 rows looking at [...]

[Read more →]




?>