Automotive Manual, Car Parts and News

This manual is written for the Honda CRX 1991 (Euro, JDM) B16A1, but also applies to other Honda cars equipped with the B16/B18 engine. The manual consists of four parts:
- Installation manual
- Performance issues
- Tuning guide
- Engine building

[Read more →]

The installation of this cold air intake does require mechanical skills. Removal of the front bumper requires loosening and removing several plastic plugs and screws that may be difficult. It is recommended that this system be installed by a professional mechanic. Be sure to disconnect the negative terminal before proceeding.
- Remove the plastic intake manifold [...]

[Read more →]

Toyota Corolla 1.6L 16v 116bhp (4A-FE Engine) 1992 – 1997
Disconnect the negative battery terminal from the battery. Carefully disconnect & remove the air temperature sensor from the air box lid. (Fig. 1) Unclip and remove the intake hose from the throttle housing. Unclip and remove the air box lid assembly from the vehicle. Unscrew and [...]

[Read more →]

1. Disconnect the negative battery cable, and remove the factory “accordion” style intake hose by loosening the two factory clamps.
2. Loosen the two 10mm bolts securing the factory air box to the intake manifold.
3. Disconnect the air temperature sensor wire on the front of the factory air box & twist to remove the sensor from [...]

[Read more →]

If for any reason the vehicle’s cooling system needs to be filled with coolant due to a service repair or maintenance, use the Coolant Refill Tool #J-45695.
• Using this tool properly will ensure complete filling without trapped air bubbles in the cooling system.
• Air pockets in the cooling system can cause:
A) Overheating
B) Poor heater performance
C) [...]

[Read more →]

1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the mass air sensor electrical connection.
3. Loosen the hose clamps on the intake hose at the throttle body and mass air sensor.
4. Using a 10mm socket, loosen and remove the bolt that holds the vacuum switch to the airbox lid.
5. Release the [...]

[Read more →]

INSTALLATION
1) Disconnect the vehicle’s negative battery cable.
2) Loosen the hose clamp where the rubber intake hose connects to the mass-air sensor.
3) On some vehicles with a manual transmission;you may need to unhook the vacuum pipe from the rubber hose junction.
4) Carefully remove the electrical plug connection from the mass-air sensor.
5) Unclip the airbox lid. Remove [...]

[Read more →]