Automotive Manual, Car Parts and News

Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen (2) hose clamps and remove rubber hose. (Ref. “C”)
3. Remove compression ring. (Ref. “B”)
4. Install power plate with a small amount of grease on the installing edge of the power plate for ease of installation. (Ref. “A”)

[Read more →]

In the vast majority of cases, the manifold may be installed without modifications, if further port matching is required, material removal should be blended up at least two inches into the runner. Since the casting lines between the runners and the plenum floor are located entirely outside of the runner entries, an ideal runner approach […]

[Read more →]

1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm socket.
5. Remove the oil filler cap (for clearance if needed) and […]

[Read more →]

On this particular model vehicle, there is not splashguard underneath the vehicle. This means that the air filter is exposed to the outside elements. Extreme care must be taken while driving the vehicle in the rain. If you have to traverse any deep water, do so with extreme caution. If rains are intense, it may […]

[Read more →]

1. Disconnect the negative battery cable, and remove the factory “accordion” style intake hose by loosening the two factory clamps.
2. Loosen the two 10mm bolts securing the factory air box to the intake manifold.
3. Disconnect the air temperature sensor wire on the front of the factory air box & twist to remove the sensor from […]

[Read more →]

Intercooler Assembly Installation:
1. Disconnect the negative battery cables from both batteries
2. Disconnect the inlet air temperature/ pressure sensor connector located on the air box cover. the connector is shown in Figure 1.
3.Remove the nut that fastens the air filter housing to the radiator cross brace.
4. Loosen the hose clamp that secures the air inlet duct […]

[Read more →]

PowerAid Throttle Body Spacer Installation Instructions for 03-08 Dodge Ram 5.7L Hemi
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm […]

[Read more →]

1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove the air cleaner.
3. Using 1/2” socket, remove (4) 5/16” bolts attaching the throttle body to the manifold.
4. Lift the throttle body.
5. Remove the old gasket and clean both the throttle body and manifold surfaces.
6. Install power plate with (2) gaskets. (Ref. A)

[Read more →]

1) Remove Engine Cover
2) Disconnect Intake Air Tube from T
3) Unplug the Drive-By-Wire Throttle Body Connector
4) Unplug the blue EVAP solenoid connector and make sure it’s free from the UIM
5) Unbolt VIAS tank and solenoid from Upper Intake Manifold (UIM)

[Read more →]

Installation of the AEM Cold Air Intake System
When installing the Cold Air Intake System, DO NOT completely tighten the hose clamps or mounting tab hardware until instructed to do so later in these instructions.
a) Pull vacuum hose off nipple on the intake manifold.
b) Cover the open nipple with the supplied vacuum cap.
c) Remove the mass […]

[Read more →]