Automotive Manual, Car Parts and News

Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Remove the battery cover and disconnect negative battery terminal.
e. Do not discard stock components after removal of the factory system.

[Read more →]

Removing the stock air intake system
a) Loosen the hose clamps attaching the primary stock intake pipe to the throttle body and the primary stock intake pipe to the mass air flow sensor.
i) Remove the primary stock intake pipe.
b) Disconnect the wiring harness from the mass air flow sensor.
c) Remove the sensor from the stock intake […]

[Read more →]

1. Turn off the ignition and disconnect the negative battery cable.
2. Disconnect mass air sensor electrical connection.
3. Rotate crank case vent hose locking ring and pull crank case vent hose off of air filter housing. Un-hook wiring harness retaining clip from air box.
3a. Disconnect the brake booster vent line from the air filter housing as […]

[Read more →]

Parts Needed: New Crank pulley Bolt (Ford part # F5RZ-6A340-B)
1: Verify that your kit has all the parts included. The kit comes complete with a smaller iron crank pulley, an oversized water pump pulley, and the instructions.
2: Remove the air intake, this step isn’t required but makes for a much easier installation when you are […]

[Read more →]

Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen (2) hose clamps and remove rubber hose. (Ref. “C”)
3. Remove compression ring. (Ref. “B”)
4. Install power plate with a small amount of grease on the installing edge of the power plate for ease of installation. (Ref. “A”)

[Read more →]

1. Turn off the ignition and disconnect the negative battery cable.
2. Loosen the hose clamp at the intake resonator as shown.
NOTE: Disconnecting the negative battery cable erases pre-programmed electronic memories. Write down all memory settings before disconnecting the negative battery cable. Some radios will require an anti-theft coded to be entered after the battery is […]

[Read more →]

To Start the installation:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Unlock the red locking tab on the air temperature sensor electrical connection, then depress the locking lever and pull apart the temperature sensor electrical connection
3. Loosen the hose clamp that secures the intake tube to the throttle body and pull […]

[Read more →]

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the air temp. sensor electrical connection.
3. Loosen the hose clamps at the turbo inlet and the airbox outlet as shown.
4. Remove the intake tube from the vehicle as shown.
5. Loosen and remove the 10mm nut that retains the airbox to the […]

[Read more →]

Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS […]

[Read more →]

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the mass air sensor electrical connection and unhook the harness from the air box.
3. Remove the two bolts shown, which secure the engine cover.
4. Lift firmly on the engine cover to dislodge it from the mounting grommets, and then remove the […]

[Read more →]