With the engine cool, remove the engine cover and the components that are highlighted red in the picture below. Remove the mounting rubber grommets from the piping and save for re-installation (highlighted green).
2011+ Nissan Juke GTM Juke Intercooler Piping Kit Installation Manual
September 26th, 2011 · No Comments
BMW 135/335 Front Mounting Intercooler Installation Instructions
June 2nd, 2011 · No Comments
Installation procedures:
1. Jack the car up and support it on the jacking points under each sill. Remove the engine undertray by removing the 16 8mm bolts. On the 135, one of the bolts is at the inside rear edge of the wheel arch on each side. The others are quite obvious.
2. Undo the screws securing [...]
