Automotive Manual, Car Parts and News

RSS Feed

Free PDF Download, Car Parts and Automotive News

Audi RS6 Front and Rear Sway Bar Kit Installation Instructions

November 3rd, 2010 · No Comments

Tools Required: 1) 4-Post lift or drive-on ramps 2) 13mm socket/wrench 3) 16mm socket/wrench 4) 3/8” drive extension (long) 5) Blue Threadlocker 6) Slotted Screwdriver
START WITH THE REAR BAR
1) Raise the rear (or entire) vehicle using a 4-Post lift or drive-on ramps. The car cannot be lifted with the suspension hanging for this installation!
2) Once [...]

[Read more →]


00-05 Mitsubishi Eclipse Rear Kit Part No. 75604

September 18th, 2010 · No Comments

Preparing the Vehicle
1. Raise the vehicle and support the body on jack stands.
2. Remove the rear wheels.
Strut Removal
1. Remove the sway bar by removing the four inner sway bar bolts and sway bar link on each side of the vehicle.
2. In the trunk compartment on one side of the vehicle, remove the plastic cover over [...]

[Read more →]


Setup Guide and Chassis Tuning Tips for Miata

August 19th, 2010 · No Comments

Expect 6-8 hours the first time you do this yourself, sometimes longer depending on your mechanical ability. This time estimate is AFTER you level your floor.
Tools and equipment needed to do setup at home:
• Level surface (absolutely level, use shims to achieve if needed)
• Scales, camber gauge, toe plates, string
• Normal tools and jack stands
• [...]

[Read more →]


Dodge Vipers Harland Sharp Roller Rocker Arm Assembly and Installation Instructions

December 5th, 2009 · No Comments

We recommend fully reading the installation instructions before beginning.
1. Begin by installing the pushrod adjuster into the rocker arm. The cupped side faces down and is where the pushrod makes contact. Screw the adjuster in until only the first thread is shown on the bottom side of the rocker arm.
2. Install the pushrod adjuster jam [...]

[Read more →]


Mazda MX-5/Eunos Front/Rear anti-roll bar drop link Installation Instructions

November 7th, 2009 · No Comments

The drop link is fully rose-jointed and is a direct replacement for the original unit. Instead of using rubber bushes to provide the articulation, it uses two rod ends to provide smoother movement — and an end to regular bush replacement. NOTE: the front and rear drop links are identical and these fitting instructions cover [...]

[Read more →]


Chrysler “B” Engines Adjustable Rocker Arms Installation Instructions

October 10th, 2009 · No Comments

Crane’s adjustable rocker arms must be installed on NEW rocker shafts. Care must be taken to install the oil feed holes in the new shafts toward the cylinder head and toward the valve springs so that oil pressure gets to the side of the shaft which is heavily loaded. These rocker arms are installed in [...]

[Read more →]




?>