Automotive Manual, Car Parts and News

Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Remove the battery cover and disconnect negative battery terminal.
e. Do not discard stock components after removal of the factory system.

[Read more →]

Before Starting Installation
1. Carefully read all warnings and instructions completely before beginning.
2. Verify all parts have been received in this kit by checking the parts list at the end of this document.
3. Only install this kit on the vehicle for which it is specified. If anytime during the installation you encounter something different from what […]

[Read more →]

As you read through this procedure, note that each part referenced has the same callout number throughout. Also, the part number in the text matches the corre- sponding part number in the art. Kit parts are prefaced by the word kit in italics.
NOTE
You will find it easier to keep track of hardware if immediately after […]

[Read more →]

On this particular model vehicle, there is not splashguard underneath the vehicle. This means that the air filter is exposed to the outside elements. Extreme care must be taken while driving the vehicle in the rain. If you have to traverse any deep water, do so with extreme caution. If rains are intense, it may […]

[Read more →]

The net amount of ride height increase depends upon the age and use of the vehicle, wheel offset, and numerous other factors. Stated torsion bar ride height in- creases are based upon factory specifications. If the torsion bars were “cranked up” at some point in the past, expect a corresponding reduction in overall height increase […]

[Read more →]

This kit is used for 2004-2005 Nissan Titan 3 and should only be installed on a vehicle that is in good working condition. Before you install the kit, thoroughly inspect the vehicle for corrosion or deformation of the sheet metal around the factory body mounts. If the vehicle is suspected to have been in a […]

[Read more →]

Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Disconnect all negative battery terminals.
e. Jack up front of the vehicle and place on properly rated jack stands.
f. Remove driver’s side fender liner.
g. Do not discard stock components after […]

[Read more →]

Park your truck on flat level surface. Chock the rear wheels. Loosen front lug nuts. Raise the front with a floor jack. Support the frame with jack stands. Remove front wheels.
NOTE : ALWAYS USE JACK STANDS - NEVER RELY ON JACKS ONLY!!
1) Starting on the drivers side, locate the height adjusting bolt at the rear […]

[Read more →]

Read and understand these instructions BEFORE attempting to install this product. Failure to follow installation instructions and not using the provided hardware may damage the intake tube, throttle body and engine.
Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool […]

[Read more →]

This kit should only be installed on a vehicle that is in good working condition. Before you install the kit, thoroughly inspect the vehicle for corrosion or deformation of the sheet metal around the factory body mounts. If the vehicle is suspected to have been in a collision or misused, do not install this kit. […]

[Read more →]