Installation Instructions: 1. Remove tailgate by disconnecting the tether cable and lifting the tailgate out at approximately a 45º angle. (Reference the truck’s Owner’s manual).
2. Carefully remove the OEM tailgate pivot cups taking note of which side they belongs to.
3. For the GM800001, remove both taillight assemblies (2 screws each). (Reference the truck’s Owner’s manual).
4. [...]
Chevrolet 1500-2500-3500 TireGate P/N GM80001, GM80004, GM80015, GM80018
December 30th, 2010 · No Comments
How and what do you use to clean 1998 Cadillac STS headlights?
December 25th, 2010 · No Comments
How do a person go by cleaning the headlights on a 1998 Cadillac STS? No matter what they use the grim will not come off. How could you get inside to get it off and what product is best to use?
1995-2000 Honda CRV/Odyssey Signal and Marker Lights Repair Information
May 31st, 2010 · No Comments
REMOVAL & INSTALLATION Front Turn Signal and Parking Lights CRV MODELS AND V6 ODYSSEY MODELS
1. Turn the steering wheel in the opposite direction from which the bulb is to be removed.
2. Using a flat blade screwdriver, remove the fasteners securing the inner fender behind the headlight and pull back on the
inner fender liner.
3. Remove the [...]
Miata Lo-Pro Headlight Instructions
October 29th, 2009 · No Comments
1. Install one Miata Lo-Pro Headlight con- version at a time starting with the Drivers side first. Please note that when “Right” or “Left” is mentioned, it is referenced from behind the steering wheel. With the headlights and the hood in the UP position remove the black plastic mask by removing the four phillips (cross) [...]
1996+ Mazda Miata Automotive Interior Light Delay Module Installation Instructions
October 28th, 2009 · No Comments
Add a delayed turn-off feature, normally found on cars costing $$$ more, to your interior cabin light. The Lights Up! light delay module will work with most switched-ground oper- ated interior lights, including multiple lights with a combinedwattage less than 15W. The Lights Up! module is equipped with two different delay options: 25 seconds and [...]
4” Submersible LED Stop/Turn Trailer Tail Light Assembly & Operating Instructions
September 29th, 2009 · No Comments
Read all instructions before using this product!
1. Keep work area clean. Cluttered areas invite injuries.
2. Observe work area conditions. Keep work area well lighted.
3. Store idle equipment. When not in use, the Tail Light must be stored in a safe and clean location. Always lock up products and keep out of reach of children.
4. Use [...]
